AutoDefects
Deutsch

Citroën C3 2021: Zuverlässigkeit

29% mehr technische Mängel als die Klasse

8.433 MOT-Prüfungen von Citroën C3 mit Erstzulassung 2021: 3,6% fielen wegen eines technischen Mangels durch; der Klassenmedian bei gleichem Alter und gleicher Laufleistung liegt bei 2,8%.

Technische Mängelquote
3,6%
Klassenmedian, gleiches Alter und gleiche Laufleistung
2,8%
Durchgefallen (jeder Grund)
9,2%
MOT-Prüfungen
8.433
Rückrufe
7

Was nach Laufleistung ausfällt

LaufleistungPrüfungenTechnische MängelKlassenmedian
0-50k km6.6232,6%1,9%
50-100k km1.6716,7%5,9%
100-150k km12212,3%8,0%
150k+ km1723,5%9,6%

Was bei diesem Baujahr ausfällt

BaugruppeTechnische Mängel
Fahrwerk und Räder0,5%
Bremsen2,0%
Motor, Abgasanlage und Emissionen0,3%
Lenkung0,0%
Karosserie, Rahmen und Rost1,0%
Gurte und Airbags0,1%
Licht und Elektrik (Verschleiß)3,4%
Reifen (Verschleiß)2,4%
Wischer und Scheibe (Verschleiß)1,1%
Sonstiges und Kennzeichen (Verschleiß)0,1%

Amtliche Rückrufe

Rückrufe der US-Behörde NHTSA und des EU Safety Gate, die dieses Modell nennen. Ob ein bestimmtes Auto betroffen ist, per FIN prüfen.

  • EU Safety Gate2015–2024

    The malfunction indicator light (MIL) may fail to illuminate if the diagnostic system of the Selective Catalytic Reduction (SCR) and/or the diesel particulate filter (DPF) malfunctions after a fault code has appeared.…

    Volltext

    The malfunction indicator light (MIL) may fail to illuminate if the diagnostic system of the Selective Catalytic Reduction (SCR) and/or the diesel particulate filter (DPF) malfunctions after a fault code has appeared. This could cause the vehicle to operate without the required warning, and resulting in emissions above the regulatory limits.

    SR/03151/25 ↗
  • EU Safety Gate2017–2023

    Due to oil carbonisation and high contact pressure, the 7 mm camshaft chain resistance can be reduced. This may cause the camshaft chain to break, leading to an engine failure. This can cause a loss of vehicle's control…

    Volltext

    Due to oil carbonisation and high contact pressure, the 7 mm camshaft chain resistance can be reduced. This may cause the camshaft chain to break, leading to an engine failure. This can cause a loss of vehicle's control and increase the risk of accidents and injuries.

    SR/02655/25 ↗
  • EU Safety Gate2019–2022

    A software error in the engine control unit prevents the malfunction indicator light (MIL) from switching on if the urea injector stops working. This can lead to higher emissions and poses a risk to the environment.

    A12/01876/23 ↗
  • EU Safety Gate2021

    Improperly tightened rear axle components can result in loss or damage to the affected part (rod for the wheel and the chassis, brake caliper, rear axle fixing, ABS sensor, brake housing, brake housing support). This…

    Volltext

    Improperly tightened rear axle components can result in loss or damage to the affected part (rod for the wheel and the chassis, brake caliper, rear axle fixing, ABS sensor, brake housing, brake housing support). This can lead to a loss of driving stability, increasing the risk of an accident.

    A11/00056/22 ↗
  • EU Safety Gate2021

    Incorrect tightening torques of some fastenings on the rear axle can lead to a loosening of connections. This may lead to the deterioration in braking performance, loss of control over the vehicle and even to a loss of…

    Volltext

    Incorrect tightening torques of some fastenings on the rear axle can lead to a loosening of connections. This may lead to the deterioration in braking performance, loss of control over the vehicle and even to a loss of a wheel, thereby endangering the surrounding traffic.

    A12/00511/22 ↗
  • EU Safety Gate2021

    The outer pinion of the right driveshaft may break due to lack of heat treatment during the manufacture of the part which may lead to a break in the transmission shaft. The engine will still run, but there is no torque…

    Volltext

    The outer pinion of the right driveshaft may break due to lack of heat treatment during the manufacture of the part which may lead to a break in the transmission shaft. The engine will still run, but there is no torque transmission to the drive wheels increasing the risk of an accident.

    A12/00028/22 ↗
1 weitere Rückrufe anzeigen
  • EU Safety Gate2020, 2021

    The fixing screws for the ball joints may be missing.This could lead to a loss of control over the vehicle during driving, increasing the risk of an accident.

    A12/00957/21 ↗