AutoDefects
Français

Citroën C3 2021 : fiabilité

29 % de défaillances mécaniques en plus que la catégorie

8 433 contrôles MOT de Citroën C3 immatriculées pour la première fois en 2021 : 3,6 % recalées pour un défaut mécanique ; la médiane de la catégorie au même âge et kilométrage est de 2,8 %.

Taux de défaillance mécanique
3,6%
Médiane de la catégorie, même âge et kilométrage
2,8%
Recalés (toute raison)
9,2%
contrôles MOT
8 433
Rappels
7

Ce qui lâche selon le kilométrage

KilométrageContrôlesDéfaillance mécaniqueMédiane catégorie
0-50k km6 6232,6%1,9%
50-100k km1 6716,7%5,9%
100-150k km12212,3%8,0%
150k+ km1723,5%9,6%

Ce qui lâche sur cette année

OrganeDéfaillance mécanique
Suspension et roues0,5%
Freins2,0%
Moteur, échappement et émissions0,3%
Direction0,0%
Carrosserie, châssis et corrosion1,0%
Ceintures et airbags0,1%
Éclairage et électricité (usure)3,4%
Pneus (usure)2,4%
Essuie-glaces et pare-brise (usure)1,1%
Divers et plaques (usure)0,1%

Rappels officiels

Rappels publiés par la NHTSA (États-Unis) et l’EU Safety Gate qui citent ce modèle. Vérifiez par VIN si une voiture précise est concernée.

  • EU Safety Gate2015–2024

    The malfunction indicator light (MIL) may fail to illuminate if the diagnostic system of the Selective Catalytic Reduction (SCR) and/or the diesel particulate filter (DPF) malfunctions after a fault code has appeared.…

    Texte complet

    The malfunction indicator light (MIL) may fail to illuminate if the diagnostic system of the Selective Catalytic Reduction (SCR) and/or the diesel particulate filter (DPF) malfunctions after a fault code has appeared. This could cause the vehicle to operate without the required warning, and resulting in emissions above the regulatory limits.

    SR/03151/25 ↗
  • EU Safety Gate2017–2023

    Due to oil carbonisation and high contact pressure, the 7 mm camshaft chain resistance can be reduced. This may cause the camshaft chain to break, leading to an engine failure. This can cause a loss of vehicle's control…

    Texte complet

    Due to oil carbonisation and high contact pressure, the 7 mm camshaft chain resistance can be reduced. This may cause the camshaft chain to break, leading to an engine failure. This can cause a loss of vehicle's control and increase the risk of accidents and injuries.

    SR/02655/25 ↗
  • EU Safety Gate2019–2022

    A software error in the engine control unit prevents the malfunction indicator light (MIL) from switching on if the urea injector stops working. This can lead to higher emissions and poses a risk to the environment.

    A12/01876/23 ↗
  • EU Safety Gate2021

    Improperly tightened rear axle components can result in loss or damage to the affected part (rod for the wheel and the chassis, brake caliper, rear axle fixing, ABS sensor, brake housing, brake housing support). This…

    Texte complet

    Improperly tightened rear axle components can result in loss or damage to the affected part (rod for the wheel and the chassis, brake caliper, rear axle fixing, ABS sensor, brake housing, brake housing support). This can lead to a loss of driving stability, increasing the risk of an accident.

    A11/00056/22 ↗
  • EU Safety Gate2021

    Incorrect tightening torques of some fastenings on the rear axle can lead to a loosening of connections. This may lead to the deterioration in braking performance, loss of control over the vehicle and even to a loss of…

    Texte complet

    Incorrect tightening torques of some fastenings on the rear axle can lead to a loosening of connections. This may lead to the deterioration in braking performance, loss of control over the vehicle and even to a loss of a wheel, thereby endangering the surrounding traffic.

    A12/00511/22 ↗
  • EU Safety Gate2021

    The outer pinion of the right driveshaft may break due to lack of heat treatment during the manufacture of the part which may lead to a break in the transmission shaft. The engine will still run, but there is no torque…

    Texte complet

    The outer pinion of the right driveshaft may break due to lack of heat treatment during the manufacture of the part which may lead to a break in the transmission shaft. The engine will still run, but there is no torque transmission to the drive wheels increasing the risk of an accident.

    A12/00028/22 ↗
Afficher 1 rappels de plus
  • EU Safety Gate2020, 2021

    The fixing screws for the ball joints may be missing.This could lead to a loss of control over the vehicle during driving, increasing the risk of an accident.

    A12/00957/21 ↗