AutoDefects
Deutsch

Citroën C3 2019: Zuverlässigkeit

5% mehr technische Mängel als die Klasse

13.577 MOT-Prüfungen von Citroën C3 mit Erstzulassung 2019: 6,2% fielen wegen eines technischen Mangels durch; der Klassenmedian bei gleichem Alter und gleicher Laufleistung liegt bei 5,9%.

Technische Mängelquote
6,2%
Klassenmedian, gleiches Alter und gleiche Laufleistung
5,9%
Durchgefallen (jeder Grund)
15,4%
MOT-Prüfungen
13.577
Rückrufe
10

Was nach Laufleistung ausfällt

LaufleistungPrüfungenTechnische MängelKlassenmedian
0-50k km6.6443,7%3,6%
50-100k km6.1918,0%7,6%
100-150k km66412,8%12,8%
150k+ km7814,1%14,3%

Was bei diesem Baujahr ausfällt

BaugruppeTechnische Mängel
Fahrwerk und Räder0,9%
Bremsen2,9%
Motor, Abgasanlage und Emissionen1,2%
Lenkung0,1%
Karosserie, Rahmen und Rost1,8%
Gurte und Airbags0,2%
Licht und Elektrik (Verschleiß)6,3%
Reifen (Verschleiß)4,5%
Wischer und Scheibe (Verschleiß)1,4%
Sonstiges und Kennzeichen (Verschleiß)0,1%

Amtliche Rückrufe

Rückrufe der US-Behörde NHTSA und des EU Safety Gate, die dieses Modell nennen. Ob ein bestimmtes Auto betroffen ist, per FIN prüfen.

  • EU Safety Gate2015–2024

    The malfunction indicator light (MIL) may fail to illuminate if the diagnostic system of the Selective Catalytic Reduction (SCR) and/or the diesel particulate filter (DPF) malfunctions after a fault code has appeared.…

    Volltext

    The malfunction indicator light (MIL) may fail to illuminate if the diagnostic system of the Selective Catalytic Reduction (SCR) and/or the diesel particulate filter (DPF) malfunctions after a fault code has appeared. This could cause the vehicle to operate without the required warning, and resulting in emissions above the regulatory limits.

    SR/03151/25 ↗
  • EU Safety Gate2017–2023

    Due to oil carbonisation and high contact pressure, the 7 mm camshaft chain resistance can be reduced. This may cause the camshaft chain to break, leading to an engine failure. This can cause a loss of vehicle's control…

    Volltext

    Due to oil carbonisation and high contact pressure, the 7 mm camshaft chain resistance can be reduced. This may cause the camshaft chain to break, leading to an engine failure. This can cause a loss of vehicle's control and increase the risk of accidents and injuries.

    SR/02655/25 ↗
  • EU Safety Gate2019–2022

    A software error in the engine control unit prevents the malfunction indicator light (MIL) from switching on if the urea injector stops working. This can lead to higher emissions and poses a risk to the environment.

    A12/01876/23 ↗
  • EU Safety Gate2019

    The high-pressure pump has not been tightened to the engine with the correct torque. As a result, fuel may leak onto the road, posing a risk to the following traffic.

    A12/01463/20 ↗
  • EU Safety Gate2019, 2020

    The wheel alignment of the front axle may be incorrect. This may result in unstable road handling of the vehicle, increasing the risk of an accident.

    A12/01172/20 ↗
  • EU Safety Gate2018, 2019

    The ballast in the rear part of the vehicle could be absent.This can impair the vehicle's directional stability, increasing the risk of an accident.

    A12/00127/20 ↗
4 weitere Rückrufe anzeigen
  • EU Safety GateErnst2019

    The steering column is not manufactured according to specifications.This may result in steering failure and loss of control over the vehicle, increasing the risk of an accident.

    A12/00034/20 ↗
  • EU Safety GateErnst2019

    The airbag control unit may be defective. As a result, the airbags could fail to inflate in the event of an accident, increasing the risk of an injury to the occupants.

    A12/1436/19 ↗
  • EU Safety Gate2019

    The rear axle connection may be inadequate and could break. As a result, the rear axle may be disconnected from the vehicle, increasing the risk of an accident.

    A12/0976/19 ↗
  • EU Safety GateErnst2016–2019

    A protruding weld stud may damage the bodywork wire harness and lead to a short-circuit. This may consequently cause a fire.

    A12/0584/19 ↗