AutoDefects
Español

Citroën C3 2019: fiabilidad

5 % más fallos mecánicos que su clase

13.577 inspecciones MOT de Citroën C3 matriculados por primera vez en 2019: el 6,2 % no pasó por un defecto mecánico; la mediana de su clase con la misma edad y kilometraje es del 5,9 %.

Tasa de fallo mecánico
6,2%
Mediana de la clase, misma edad y kilometraje
5,9%
No pasó la MOT (cualquier motivo)
15,4%
inspecciones MOT
13.577
Llamadas a revisión
10

Qué falla según el kilometraje

KilometrajeInspeccionesFallo mecánicoMediana de la clase
0-50k km66443,7%3,6%
50-100k km61918,0%7,6%
100-150k km66412,8%12,8%
150k+ km7814,1%14,3%

Qué falla en este año

SistemaFallo mecánico
Suspensión y ruedas0,9%
Frenos2,9%
Motor, escape y emisiones1,2%
Dirección0,1%
Carrocería, bastidor y corrosión1,8%
Cinturones y airbags0,2%
Luces y electricidad (desgaste)6,3%
Neumáticos (desgaste)4,5%
Escobillas y parabrisas (desgaste)1,4%
Otros y matrículas (desgaste)0,1%

Llamadas a revisión oficiales

Campañas publicadas por la NHTSA (EE. UU.) y el EU Safety Gate que citan este modelo. Comprueba por VIN si afecta a un coche concreto.

  • EU Safety Gate2015–2024

    The malfunction indicator light (MIL) may fail to illuminate if the diagnostic system of the Selective Catalytic Reduction (SCR) and/or the diesel particulate filter (DPF) malfunctions after a fault code has appeared.…

    Texto completo

    The malfunction indicator light (MIL) may fail to illuminate if the diagnostic system of the Selective Catalytic Reduction (SCR) and/or the diesel particulate filter (DPF) malfunctions after a fault code has appeared. This could cause the vehicle to operate without the required warning, and resulting in emissions above the regulatory limits.

    SR/03151/25 ↗
  • EU Safety Gate2017–2023

    Due to oil carbonisation and high contact pressure, the 7 mm camshaft chain resistance can be reduced. This may cause the camshaft chain to break, leading to an engine failure. This can cause a loss of vehicle's control…

    Texto completo

    Due to oil carbonisation and high contact pressure, the 7 mm camshaft chain resistance can be reduced. This may cause the camshaft chain to break, leading to an engine failure. This can cause a loss of vehicle's control and increase the risk of accidents and injuries.

    SR/02655/25 ↗
  • EU Safety Gate2019–2022

    A software error in the engine control unit prevents the malfunction indicator light (MIL) from switching on if the urea injector stops working. This can lead to higher emissions and poses a risk to the environment.

    A12/01876/23 ↗
  • EU Safety Gate2019

    The high-pressure pump has not been tightened to the engine with the correct torque. As a result, fuel may leak onto the road, posing a risk to the following traffic.

    A12/01463/20 ↗
  • EU Safety Gate2019, 2020

    The wheel alignment of the front axle may be incorrect. This may result in unstable road handling of the vehicle, increasing the risk of an accident.

    A12/01172/20 ↗
  • EU Safety Gate2018, 2019

    The ballast in the rear part of the vehicle could be absent.This can impair the vehicle's directional stability, increasing the risk of an accident.

    A12/00127/20 ↗
Mostrar 4 llamadas más
  • EU Safety GateGrave2019

    The steering column is not manufactured according to specifications.This may result in steering failure and loss of control over the vehicle, increasing the risk of an accident.

    A12/00034/20 ↗
  • EU Safety GateGrave2019

    The airbag control unit may be defective. As a result, the airbags could fail to inflate in the event of an accident, increasing the risk of an injury to the occupants.

    A12/1436/19 ↗
  • EU Safety Gate2019

    The rear axle connection may be inadequate and could break. As a result, the rear axle may be disconnected from the vehicle, increasing the risk of an accident.

    A12/0976/19 ↗
  • EU Safety GateGrave2016–2019

    A protruding weld stud may damage the bodywork wire harness and lead to a short-circuit. This may consequently cause a fire.

    A12/0584/19 ↗