AutoDefects
English

Citroën C3 2019: reliability

5% more mechanical failures than the class

13,577 MOT tests of Citroën C3 cars first registered in 2019: 6.2% failed for a mechanical defect; the class median at the same age and mileage is 5.9%.

Mechanical failure rate
6.2%
Class median, same age and mileage
5.9%
Failed MOT (any reason)
15.4%
MOT tests
13,577
Recalls
10

What fails, by mileage

MileageTestsMechanical failClass median
0-50k km6,6443.7%3.6%
50-100k km6,1918.0%7.6%
100-150k km66412.8%12.8%
150k+ km7814.1%14.3%

What fails on this year

SystemMechanical fail
Suspension and wheels0.9%
Brakes2.9%
Engine, exhaust and emissions1.2%
Steering0.1%
Body, chassis and corrosion1.8%
Seat belts and airbags0.2%
Lights and electrics (wear)6.3%
Tyres (wear)4.5%
Wipers and windscreen (wear)1.4%
Other and plates (wear)0.1%

Official recalls

Recalls published by the US NHTSA and the EU Safety Gate that name this model. Check by VIN whether a specific car is affected.

  • EU Safety Gate2015–2024

    The malfunction indicator light (MIL) may fail to illuminate if the diagnostic system of the Selective Catalytic Reduction (SCR) and/or the diesel particulate filter (DPF) malfunctions after a fault code has appeared.…

    Full text

    The malfunction indicator light (MIL) may fail to illuminate if the diagnostic system of the Selective Catalytic Reduction (SCR) and/or the diesel particulate filter (DPF) malfunctions after a fault code has appeared. This could cause the vehicle to operate without the required warning, and resulting in emissions above the regulatory limits.

    SR/03151/25 ↗
  • EU Safety Gate2017–2023

    Due to oil carbonisation and high contact pressure, the 7 mm camshaft chain resistance can be reduced. This may cause the camshaft chain to break, leading to an engine failure. This can cause a loss of vehicle's control…

    Full text

    Due to oil carbonisation and high contact pressure, the 7 mm camshaft chain resistance can be reduced. This may cause the camshaft chain to break, leading to an engine failure. This can cause a loss of vehicle's control and increase the risk of accidents and injuries.

    SR/02655/25 ↗
  • EU Safety Gate2019–2022

    A software error in the engine control unit prevents the malfunction indicator light (MIL) from switching on if the urea injector stops working. This can lead to higher emissions and poses a risk to the environment.

    A12/01876/23 ↗
  • EU Safety Gate2019

    The high-pressure pump has not been tightened to the engine with the correct torque. As a result, fuel may leak onto the road, posing a risk to the following traffic.

    A12/01463/20 ↗
  • EU Safety Gate2019, 2020

    The wheel alignment of the front axle may be incorrect. This may result in unstable road handling of the vehicle, increasing the risk of an accident.

    A12/01172/20 ↗
  • EU Safety Gate2018, 2019

    The ballast in the rear part of the vehicle could be absent.This can impair the vehicle's directional stability, increasing the risk of an accident.

    A12/00127/20 ↗
Show 4 more recalls
  • EU Safety GateSerious2019

    The steering column is not manufactured according to specifications.This may result in steering failure and loss of control over the vehicle, increasing the risk of an accident.

    A12/00034/20 ↗
  • EU Safety GateSerious2019

    The airbag control unit may be defective. As a result, the airbags could fail to inflate in the event of an accident, increasing the risk of an injury to the occupants.

    A12/1436/19 ↗
  • EU Safety Gate2019

    The rear axle connection may be inadequate and could break. As a result, the rear axle may be disconnected from the vehicle, increasing the risk of an accident.

    A12/0976/19 ↗
  • EU Safety GateSerious2016–2019

    A protruding weld stud may damage the bodywork wire harness and lead to a short-circuit. This may consequently cause a fire.

    A12/0584/19 ↗