Small SUVs
Citroën C3 Aircross reliability
In 29,663 UK MOT tests, 9.0% of Citroën C3 Aircross cars failed for a mechanical or structural defect. The median small SUV of the same age and mileage: 4.5%.
- Best years
- —
- Years with most failures
- 2018, 2019, 2021
- Weak spot at high mileage
- Body, chassis and corrosion
- Official recalls
- 8 recalls, 4 serious
- Mechanical failure rate
- 9.0%
- Class median, same age and mileage
- 4.5%
- MOT tests
- 29,663
- US owner complaints
- 0
Failure rate by year of first registration
Mechanical failure rate at the 2024 MOT, by the year the car was first registered, against the median of its class at the same age and mileage.
What fails, by mileage
Share of MOT tests that failed on each system. Wear items (bulbs, tyres, wipers, plates) are excluded from the reliability score.
(…) = Class median, same age and mileage
Pre-purchase checklist for the mechanic
Built from the systems where this model fails more often than its class at 100,000 km and above, and from open recalls.
- Body and chassis: inspect sills, subframes, jacking points and the floor for corrosion and previous repairs.
- Recalls: ask for proof that open recall work for this model has been done (the dealer can check by VIN).
Official recalls
Recalls published by the US NHTSA and the EU Safety Gate that name this model. Check by VIN whether a specific car is affected.
Due to a defect in the engine control unit (inverter) in vehicles equipped with electrified dual-clutch transmission (e-DCT), metal soldering residues may pass into the unit. This can cause internal electric short…
SR/01382/26 ↗Full text
Due to a defect in the engine control unit (inverter) in vehicles equipped with electrified dual-clutch transmission (e-DCT), metal soldering residues may pass into the unit. This can cause internal electric short circuits which, can lead to continuous power supply and overheating due to a blocked relay, and cause a fire.
The electric power steering harness being routed between two screws, and slight vibrations may cause damage during steering operations. This may cause a short circuit, leading to a loss of power steering assistance…
SR/00905/26 ↗Full text
The electric power steering harness being routed between two screws, and slight vibrations may cause damage during steering operations. This may cause a short circuit, leading to a loss of power steering assistance and/or a fire in the passenger compartment.
There is insufficient clearance (< 10 mm), between the tube of the petrol particulate filter and the terminal protection cap of the 48 V belt-driven starter alternator. In wet conditions, the insufficient clearance and…
SR/00841/26 ↗Full text
There is insufficient clearance (< 10 mm), between the tube of the petrol particulate filter and the terminal protection cap of the 48 V belt-driven starter alternator. In wet conditions, the insufficient clearance and contact between these components can lead to water infiltration, causing an electric arc which may trigger a thermal event, such as overheating. There is a risk of fire.
The vehicle may have a fuel leak in the high-pressure hose, between the high-pressure pump and the rail, because of loose nuts. This may cause a fire in the vehicle.
SR/02935/25 ↗The brake pedal support may not be attached securely enough due to a missing or poorly assembled pin. If the pin falls, the brake pedal could disengage, making it impossible to stop the vehicle. This may lead to…
SR/04252/25 ↗Full text
The brake pedal support may not be attached securely enough due to a missing or poorly assembled pin. If the pin falls, the brake pedal could disengage, making it impossible to stop the vehicle. This may lead to injuries. If the brake pedal fails, the electronic parking brake on the centre console may be used while driving to slow the vehicle down to a controlled stop. Furthermore, when active, the automatic emergency braking system intervenes when it detects an imminent collision.
The malfunction indicator light (MIL) may fail to illuminate if the diagnostic system of the Selective Catalytic Reduction (SCR) and/or the diesel particulate filter (DPF) malfunctions after a fault code has appeared.…
SR/03151/25 ↗Full text
The malfunction indicator light (MIL) may fail to illuminate if the diagnostic system of the Selective Catalytic Reduction (SCR) and/or the diesel particulate filter (DPF) malfunctions after a fault code has appeared. This could cause the vehicle to operate without the required warning, and resulting in emissions above the regulatory limits.
Show 2 more recalls
Due to oil carbonisation and high contact pressure, the 7 mm camshaft chain resistance can be reduced. This may cause the camshaft chain to break, leading to an engine failure. This can cause a loss of vehicle's control…
SR/02655/25 ↗Full text
Due to oil carbonisation and high contact pressure, the 7 mm camshaft chain resistance can be reduced. This may cause the camshaft chain to break, leading to an engine failure. This can cause a loss of vehicle's control and increase the risk of accidents and injuries.
Due to a faulty software of the electronic engine control unit (ECU), an incorrect value may be given when the data are processed by the vehicle. This may result in nitrogen oxide (NOx) emissions above the regulatory…
SR/00435/25 ↗Full text
Due to a faulty software of the electronic engine control unit (ECU), an incorrect value may be given when the data are processed by the vehicle. This may result in nitrogen oxide (NOx) emissions above the regulatory limits. Excessive NOx emissions pose a risk to the environment.