AutoDefects
Polski

Citroën C3 2018: niezawodność

Na poziomie klasy

15 930 badań MOT egzemplarzy Citroën C3 zarejestrowanych po raz pierwszy w 2018: 9,0% nie przeszło z powodu usterki mechanicznej; mediana klasy w tym samym wieku i z tym samym przebiegiem to 9,2%.

Usterki mechaniczne
9,0%
Mediana klasy, ten sam wiek i przebieg
9,2%
Negatywne badanie (dowolny powód)
20,2%
badań MOT
15 930
Akcje przywoławcze
7

Co się psuje w zależności od przebiegu

PrzebiegBadaniaUsterki mechaniczneMediana klasy
0-50k km48844,8%5,2%
50-100k km91209,3%9,9%
100-150k km167617,1%15,3%
150k+ km25023,2%19,3%

Co się psuje w tym roczniku

UkładUsterki mechaniczne
Zawieszenie i koła1,9%
Hamulce3,1%
Silnik, wydech i emisja2,4%
Układ kierowniczy0,3%
Nadwozie, podwozie i korozja2,7%
Pasy i poduszki powietrzne0,2%
Oświetlenie i elektryka (eksploatacja)8,2%
Opony (eksploatacja)5,3%
Wycieraczki i szyba (eksploatacja)2,7%
Inne i tablice (eksploatacja)0,1%

Oficjalne akcje przywoławcze

Akcje opublikowane przez NHTSA (USA) i EU Safety Gate, w których wymieniono ten model. Czy dotyczą konkretnego auta, sprawdź po VIN.

  • EU Safety Gate2015–2024

    The malfunction indicator light (MIL) may fail to illuminate if the diagnostic system of the Selective Catalytic Reduction (SCR) and/or the diesel particulate filter (DPF) malfunctions after a fault code has appeared.…

    Pełny tekst

    The malfunction indicator light (MIL) may fail to illuminate if the diagnostic system of the Selective Catalytic Reduction (SCR) and/or the diesel particulate filter (DPF) malfunctions after a fault code has appeared. This could cause the vehicle to operate without the required warning, and resulting in emissions above the regulatory limits.

    SR/03151/25 ↗
  • EU Safety Gate2017–2023

    Due to oil carbonisation and high contact pressure, the 7 mm camshaft chain resistance can be reduced. This may cause the camshaft chain to break, leading to an engine failure. This can cause a loss of vehicle's control…

    Pełny tekst

    Due to oil carbonisation and high contact pressure, the 7 mm camshaft chain resistance can be reduced. This may cause the camshaft chain to break, leading to an engine failure. This can cause a loss of vehicle's control and increase the risk of accidents and injuries.

    SR/02655/25 ↗
  • EU Safety Gate2014–2018

    The teeth of the timing belt may wear off prematurely due to excessive dynamic tension in dusty conditions. As a result, the engine may stall at high engine speeds and not being able to restart, increasing the risk of…

    Pełny tekst

    The teeth of the timing belt may wear off prematurely due to excessive dynamic tension in dusty conditions. As a result, the engine may stall at high engine speeds and not being able to restart, increasing the risk of an accident. The product does not meet the requirements laid down in the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.

    A12/01186/21 ↗
  • EU Safety Gate2018, 2019

    The ballast in the rear part of the vehicle could be absent.This can impair the vehicle's directional stability, increasing the risk of an accident.

    A12/00127/20 ↗
  • EU Safety GatePoważne2016–2019

    A protruding weld stud may damage the bodywork wire harness and lead to a short-circuit. This may consequently cause a fire.

    A12/0584/19 ↗
  • EU Safety GatePoważne2018

    The steering column may have been incorrectly fixed to the shaft of the vehicle's steering system. The steering column might consequently detach from the steering system, leading to a loss of steering control.

    A12/0238/19 ↗
Pokaż jeszcze 1 akcji
  • EU Safety GatePoważne2018

    The steering column assembly may not be correct. This could lead to a loss of steering control.

    A12/1357/18 ↗