AutoDefects
Українська

Citroën C3 2018: надійність

на 18% менше механічних відмов, ніж у класі

15 930 техоглядів Citroën C3 першої реєстрації 2018 року: 9,0% не пройшли через механічний дефект; медіана класу того ж віку й пробігу — 11,0%.

Відмови через механіку
9,0%
Медіана класу, той самий вік і пробіг
11,0%
Не пройшли MOT (будь-яка причина)
20,2%
техоглядів MOT
15 930
Відкликання
7

Що ламається залежно від пробігу

ПробігТехоглядиМеханічні відмовиМедіана класу
0-50k km4 8844,8%6,2%
50-100k km9 1209,3%12,2%
100-150k km1 67617,1%17,1%
150k+ km25023,2%18,3%

Що ламається в цьому році випуску

СистемаМеханічні відмови
Підвіска й колеса1,9%
Гальма3,1%
Двигун, вихлоп і викиди2,4%
Кермове керування0,3%
Кузов, рама й корозія2,7%
Ремені й подушки безпеки0,2%
Світло й електрика (витратні)8,2%
Шини (витратні)5,3%
Щітки й лобове скло (витратні)2,7%
Інше й номери (витратні)0,1%

Офіційні відкликання

Відкликання, опубліковані NHTSA (США) та EU Safety Gate, у яких названо цю модель. Чи стосується це конкретного авто, перевіряйте за VIN.

  • EU Safety Gate2015–2024

    The malfunction indicator light (MIL) may fail to illuminate if the diagnostic system of the Selective Catalytic Reduction (SCR) and/or the diesel particulate filter (DPF) malfunctions after a fault code has appeared.…

    Повний текст

    The malfunction indicator light (MIL) may fail to illuminate if the diagnostic system of the Selective Catalytic Reduction (SCR) and/or the diesel particulate filter (DPF) malfunctions after a fault code has appeared. This could cause the vehicle to operate without the required warning, and resulting in emissions above the regulatory limits.

    SR/03151/25 ↗
  • EU Safety Gate2017–2023

    Due to oil carbonisation and high contact pressure, the 7 mm camshaft chain resistance can be reduced. This may cause the camshaft chain to break, leading to an engine failure. This can cause a loss of vehicle's control…

    Повний текст

    Due to oil carbonisation and high contact pressure, the 7 mm camshaft chain resistance can be reduced. This may cause the camshaft chain to break, leading to an engine failure. This can cause a loss of vehicle's control and increase the risk of accidents and injuries.

    SR/02655/25 ↗
  • EU Safety Gate2014–2018

    The teeth of the timing belt may wear off prematurely due to excessive dynamic tension in dusty conditions. As a result, the engine may stall at high engine speeds and not being able to restart, increasing the risk of…

    Повний текст

    The teeth of the timing belt may wear off prematurely due to excessive dynamic tension in dusty conditions. As a result, the engine may stall at high engine speeds and not being able to restart, increasing the risk of an accident. The product does not meet the requirements laid down in the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.

    A12/01186/21 ↗
  • EU Safety Gate2018, 2019

    The ballast in the rear part of the vehicle could be absent.This can impair the vehicle's directional stability, increasing the risk of an accident.

    A12/00127/20 ↗
  • EU Safety GateСерйозне2016–2019

    A protruding weld stud may damage the bodywork wire harness and lead to a short-circuit. This may consequently cause a fire.

    A12/0584/19 ↗
  • EU Safety GateСерйозне2018

    The steering column may have been incorrectly fixed to the shaft of the vehicle's steering system. The steering column might consequently detach from the steering system, leading to a loss of steering control.

    A12/0238/19 ↗
Показати ще 1 відкликань
  • EU Safety GateСерйозне2018

    The steering column assembly may not be correct. This could lead to a loss of steering control.

    A12/1357/18 ↗