Jaguar E-PACE 2020: Zuverlässigkeit
6.278 MOT-Prüfungen von Jaguar E-PACE mit Erstzulassung 2020: 3,6% fielen wegen eines technischen Mangels durch; der Klassenmedian bei gleichem Alter und gleicher Laufleistung liegt bei 2,7%.
- Technische Mängelquote
- 3,6%
- Klassenmedian, gleiches Alter und gleiche Laufleistung
- 2,7%
- Durchgefallen (jeder Grund)
- 10,3%
- MOT-Prüfungen
- 6.278
- Rückrufe
- 4
Was nach Laufleistung ausfällt
| Laufleistung | Prüfungen | Technische Mängel | Klassenmedian |
|---|---|---|---|
| 0-50k km | 3.381 | 2,5% | 1,9% |
| 50-100k km | 2.679 | 4,6% | 3,5% |
| 100-150k km | 200 | 7,0% | 5,4% |
| 150k+ km | 18 | 16,7% | 5,5% |
Was bei diesem Baujahr ausfällt
Amtliche Rückrufe
Rückrufe der US-Behörde NHTSA und des EU Safety Gate, die dieses Modell nennen. Ob ein bestimmtes Auto betroffen ist, per FIN prüfen.
A defective module has been installed in the high-voltage battery, which may cause it to overheat and could lead to a fire.
SR/01969/26 ↗The front-seat passenger airbag is incorrectly folded and may therefore tear when it is deployed. This may cause injuries to passengers. In addition, hot gases could leak out and vehicle occupants could sustain burns.
SR/04434/25 ↗During its deployment, the passenger airbag may tear due to the facial airbag deployment door panel not being sufficiently weakened. A torn airbag may reduce the occupant protection, increase risk of injuries in the…
A12/02472/24 ↗Volltext
During its deployment, the passenger airbag may tear due to the facial airbag deployment door panel not being sufficiently weakened. A torn airbag may reduce the occupant protection, increase risk of injuries in the event of an accident.Moreover, a torn airbag could release hot gases, causing burns to occupants.
Due to manufacturing defect, the support wire grid between the inner and outer layers of the fuel injector rubber return pipe may not provide sufficient support, which may cause the pipe to bend and break over time. As…
A12/01349/21 ↗Volltext
Due to manufacturing defect, the support wire grid between the inner and outer layers of the fuel injector rubber return pipe may not provide sufficient support, which may cause the pipe to bend and break over time. As a result, fuel could leak into the cold side of the motor compartment and onto the road surface, posing a risk to the following traffic.