AutoDefects
English

Jaguar E-PACE 2020: reliability

35% more mechanical failures than the class

6,278 MOT tests of Jaguar E-PACE cars first registered in 2020: 3.6% failed for a mechanical defect; the class median at the same age and mileage is 2.7%.

Mechanical failure rate
3.6%
Class median, same age and mileage
2.7%
Failed MOT (any reason)
10.3%
MOT tests
6,278
Recalls
4

What fails, by mileage

MileageTestsMechanical failClass median
0-50k km3,3812.5%1.9%
50-100k km2,6794.6%3.5%
100-150k km2007.0%5.4%
150k+ km1816.7%5.5%

What fails on this year

SystemMechanical fail
Suspension and wheels0.3%
Brakes1.9%
Engine, exhaust and emissions1.6%
Steering0.0%
Body, chassis and corrosion0.1%
Seat belts and airbags0.1%
Lights and electrics (wear)1.8%
Tyres (wear)4.0%
Wipers and windscreen (wear)2.1%
Other and plates (wear)0.3%

Official recalls

Recalls published by the US NHTSA and the EU Safety Gate that name this model. Check by VIN whether a specific car is affected.

  • EU Safety GateSerious2020–2024

    A defective module has been installed in the high-voltage battery, which may cause it to overheat and could lead to a fire.

    SR/01969/26 ↗
  • EU Safety GateSerious2020–2024

    The front-seat passenger airbag is incorrectly folded and may therefore tear when it is deployed. This may cause injuries to passengers. In addition, hot gases could leak out and vehicle occupants could sustain burns.

    SR/04434/25 ↗
  • EU Safety GateSerious2020–2022

    During its deployment, the passenger airbag may tear due to the facial airbag deployment door panel not being sufficiently weakened. A torn airbag may reduce the occupant protection, increase risk of injuries in the…

    Full text

    During its deployment, the passenger airbag may tear due to the facial airbag deployment door panel not being sufficiently weakened. A torn airbag may reduce the occupant protection, increase risk of injuries in the event of an accident.Moreover, a torn airbag could release hot gases, causing burns to occupants.

    A12/02472/24 ↗
  • EU Safety Gate2019–2021

    Due to manufacturing defect, the support wire grid between the inner and outer layers of the fuel injector rubber return pipe may not provide sufficient support, which may cause the pipe to bend and break over time. As…

    Full text

    Due to manufacturing defect, the support wire grid between the inner and outer layers of the fuel injector rubber return pipe may not provide sufficient support, which may cause the pipe to bend and break over time. As a result, fuel could leak into the cold side of the motor compartment and onto the road surface, posing a risk to the following traffic.

    A12/01349/21 ↗