Jaguar E-PACE 2020: niezawodność
6278 badań MOT egzemplarzy Jaguar E-PACE zarejestrowanych po raz pierwszy w 2020: 3,6% nie przeszło z powodu usterki mechanicznej; mediana klasy w tym samym wieku i z tym samym przebiegiem to 2,7%.
- Usterki mechaniczne
- 3,6%
- Mediana klasy, ten sam wiek i przebieg
- 2,7%
- Negatywne badanie (dowolny powód)
- 10,3%
- badań MOT
- 6278
- Akcje przywoławcze
- 4
Co się psuje w zależności od przebiegu
| Przebieg | Badania | Usterki mechaniczne | Mediana klasy |
|---|---|---|---|
| 0-50k km | 3381 | 2,5% | 1,9% |
| 50-100k km | 2679 | 4,6% | 3,5% |
| 100-150k km | 200 | 7,0% | 5,4% |
| 150k+ km | 18 | 16,7% | 5,5% |
Co się psuje w tym roczniku
Oficjalne akcje przywoławcze
Akcje opublikowane przez NHTSA (USA) i EU Safety Gate, w których wymieniono ten model. Czy dotyczą konkretnego auta, sprawdź po VIN.
A defective module has been installed in the high-voltage battery, which may cause it to overheat and could lead to a fire.
SR/01969/26 ↗The front-seat passenger airbag is incorrectly folded and may therefore tear when it is deployed. This may cause injuries to passengers. In addition, hot gases could leak out and vehicle occupants could sustain burns.
SR/04434/25 ↗During its deployment, the passenger airbag may tear due to the facial airbag deployment door panel not being sufficiently weakened. A torn airbag may reduce the occupant protection, increase risk of injuries in the…
A12/02472/24 ↗Pełny tekst
During its deployment, the passenger airbag may tear due to the facial airbag deployment door panel not being sufficiently weakened. A torn airbag may reduce the occupant protection, increase risk of injuries in the event of an accident.Moreover, a torn airbag could release hot gases, causing burns to occupants.
Due to manufacturing defect, the support wire grid between the inner and outer layers of the fuel injector rubber return pipe may not provide sufficient support, which may cause the pipe to bend and break over time. As…
A12/01349/21 ↗Pełny tekst
Due to manufacturing defect, the support wire grid between the inner and outer layers of the fuel injector rubber return pipe may not provide sufficient support, which may cause the pipe to bend and break over time. As a result, fuel could leak into the cold side of the motor compartment and onto the road surface, posing a risk to the following traffic.