AutoDefects
Українська

Jaguar E-PACE 2020: надійність

на 35% більше механічних відмов, ніж у класі

6 278 техоглядів Jaguar E-PACE першої реєстрації 2020 року: 3,6% не пройшли через механічний дефект; медіана класу того ж віку й пробігу — 2,7%.

Відмови через механіку
3,6%
Медіана класу, той самий вік і пробіг
2,7%
Не пройшли MOT (будь-яка причина)
10,3%
техоглядів MOT
6 278
Відкликання
4

Що ламається залежно від пробігу

ПробігТехоглядиМеханічні відмовиМедіана класу
0-50k km3 3812,5%1,9%
50-100k km2 6794,6%3,5%
100-150k km2007,0%5,4%
150k+ km1816,7%5,5%

Що ламається в цьому році випуску

СистемаМеханічні відмови
Підвіска й колеса0,3%
Гальма1,9%
Двигун, вихлоп і викиди1,6%
Кермове керування0,0%
Кузов, рама й корозія0,1%
Ремені й подушки безпеки0,1%
Світло й електрика (витратні)1,8%
Шини (витратні)4,0%
Щітки й лобове скло (витратні)2,1%
Інше й номери (витратні)0,3%

Офіційні відкликання

Відкликання, опубліковані NHTSA (США) та EU Safety Gate, у яких названо цю модель. Чи стосується це конкретного авто, перевіряйте за VIN.

  • EU Safety GateСерйозне2020–2024

    A defective module has been installed in the high-voltage battery, which may cause it to overheat and could lead to a fire.

    SR/01969/26 ↗
  • EU Safety GateСерйозне2020–2024

    The front-seat passenger airbag is incorrectly folded and may therefore tear when it is deployed. This may cause injuries to passengers. In addition, hot gases could leak out and vehicle occupants could sustain burns.

    SR/04434/25 ↗
  • EU Safety GateСерйозне2020–2022

    During its deployment, the passenger airbag may tear due to the facial airbag deployment door panel not being sufficiently weakened. A torn airbag may reduce the occupant protection, increase risk of injuries in the…

    Повний текст

    During its deployment, the passenger airbag may tear due to the facial airbag deployment door panel not being sufficiently weakened. A torn airbag may reduce the occupant protection, increase risk of injuries in the event of an accident.Moreover, a torn airbag could release hot gases, causing burns to occupants.

    A12/02472/24 ↗
  • EU Safety Gate2019–2021

    Due to manufacturing defect, the support wire grid between the inner and outer layers of the fuel injector rubber return pipe may not provide sufficient support, which may cause the pipe to bend and break over time. As…

    Повний текст

    Due to manufacturing defect, the support wire grid between the inner and outer layers of the fuel injector rubber return pipe may not provide sufficient support, which may cause the pipe to bend and break over time. As a result, fuel could leak into the cold side of the motor compartment and onto the road surface, posing a risk to the following traffic.

    A12/01349/21 ↗