Jaguar E-PACE 2020: fiabilidad
6278 inspecciones MOT de Jaguar E-PACE matriculados por primera vez en 2020: el 3,6 % no pasó por un defecto mecánico; la mediana de su clase con la misma edad y kilometraje es del 2,7 %.
- Tasa de fallo mecánico
- 3,6%
- Mediana de la clase, misma edad y kilometraje
- 2,7%
- No pasó la MOT (cualquier motivo)
- 10,3%
- inspecciones MOT
- 6278
- Llamadas a revisión
- 4
Qué falla según el kilometraje
| Kilometraje | Inspecciones | Fallo mecánico | Mediana de la clase |
|---|---|---|---|
| 0-50k km | 3381 | 2,5% | 1,9% |
| 50-100k km | 2679 | 4,6% | 3,5% |
| 100-150k km | 200 | 7,0% | 5,4% |
| 150k+ km | 18 | 16,7% | 5,5% |
Qué falla en este año
Llamadas a revisión oficiales
Campañas publicadas por la NHTSA (EE. UU.) y el EU Safety Gate que citan este modelo. Comprueba por VIN si afecta a un coche concreto.
A defective module has been installed in the high-voltage battery, which may cause it to overheat and could lead to a fire.
SR/01969/26 ↗The front-seat passenger airbag is incorrectly folded and may therefore tear when it is deployed. This may cause injuries to passengers. In addition, hot gases could leak out and vehicle occupants could sustain burns.
SR/04434/25 ↗During its deployment, the passenger airbag may tear due to the facial airbag deployment door panel not being sufficiently weakened. A torn airbag may reduce the occupant protection, increase risk of injuries in the…
A12/02472/24 ↗Texto completo
During its deployment, the passenger airbag may tear due to the facial airbag deployment door panel not being sufficiently weakened. A torn airbag may reduce the occupant protection, increase risk of injuries in the event of an accident.Moreover, a torn airbag could release hot gases, causing burns to occupants.
Due to manufacturing defect, the support wire grid between the inner and outer layers of the fuel injector rubber return pipe may not provide sufficient support, which may cause the pipe to bend and break over time. As…
A12/01349/21 ↗Texto completo
Due to manufacturing defect, the support wire grid between the inner and outer layers of the fuel injector rubber return pipe may not provide sufficient support, which may cause the pipe to bend and break over time. As a result, fuel could leak into the cold side of the motor compartment and onto the road surface, posing a risk to the following traffic.