AutoDefects
Deutsch

Kompaktklasse

Citroën C4: Zuverlässigkeit

Bei 135.745 britischen MOT-Prüfungen fielen 27,0% der Citroën C4 wegen eines technischen oder Karosseriemangels durch. Median eines Kompaktwagens gleichen Alters und gleicher Laufleistung: 18,4%.

43von 100Unterdurchschnittlich47% mehr technische Mängel als die Klasse
Beste Baujahre
—
Baujahre mit den meisten Mängeln
2016, 2020, 2021
Schwachstelle bei hoher Laufleistung
Karosserie, Rahmen und Rost, Lenkung, Fahrwerk und Räder
Amtliche Rückrufe
9 Rückrufe, davon 3 ernst
Technische Mängelquote
27,0%
Klassenmedian, gleiches Alter und gleiche Laufleistung
18,4%
MOT-Prüfungen
135.745
Beschwerden von US-Haltern
0

Mängelquote nach Jahr der Erstzulassung

Technische Mängelquote bei der MOT-Prüfung 2024 nach Jahr der Erstzulassung, verglichen mit dem Klassenmedian bei gleichem Alter und gleicher Laufleistung.

Dieses ModellKlassenmedian
0%14%28%2005: 33,1%2005 Klassenmedian: 32,5%052006: 36,2%2006 Klassenmedian: 31,8%062007: 35,7%2007 Klassenmedian: 33,5%072008: 38,3%2008 Klassenmedian: 33,1%082009: 37,7%2009 Klassenmedian: 30,4%092010: 36,3%2010 Klassenmedian: 29,4%102011: 33,0%2011 Klassenmedian: 26,5%112012: 30,3%2012 Klassenmedian: 23,0%122013: 31,1%2013 Klassenmedian: 20,4%132014: 31,0%2014 Klassenmedian: 19,1%142015: 24,2%2015 Klassenmedian: 13,5%152016: 21,9%2016 Klassenmedian: 10,7%162017: 16,3%2017 Klassenmedian: 9,1%172018: 11,1%2018 Klassenmedian: 6,6%182019: 9,1%2019 Klassenmedian: 5,1%192020: 7,0%2020 Klassenmedian: 3,9%202021: 6,3%2021 Klassenmedian: 2,8%212022: 5,1%2022 Klassenmedian: 2,1%22
JahrPrüfungenTechnische MängelKlassenmedianAlle MängelRückrufe
20222975,1%2,1%13,1%5
20215.1926,3%2,8%17,9%2
20201.7637,0%3,9%15,8%2
20195.1739,1%5,1%21,1%2
20182.77711,1%6,6%23,5%2
201798816,3%9,1%26,6%3
201617.45021,9%10,7%34,4%2
201527.53124,2%13,5%37,7%2
201420.53531,0%19,1%42,1%1
201312.10131,1%20,4%44,8%1
20128.40030,3%23,0%44,6%1
20116.98533,0%26,5%45,2%1
20106.08436,3%29,4%52,1%1
20095.09337,7%30,4%51,9%1
20087.10938,3%33,1%53,1%0
20075.49035,7%33,5%50,7%0
20061.80936,2%31,8%51,2%0
200592133,1%32,5%46,8%0

Was nach Laufleistung ausfällt

Anteil der Prüfungen, die an der jeweiligen Baugruppe scheiterten. Verschleißteile (Lampen, Reifen, Wischer, Kennzeichen) zählen nicht zum Zuverlässigkeitswert.

Baugruppe0-50k km50-100k km100-150k km150k+ km
Technische Mängel7,1% (3,5)18,8% (10,4)28,7% (18,6)35,6% (27,1)
Prüfungen10.18932.85946.83345.864
Fahrwerk und Räder2,1% (1,1)6,7% (3,9)13,3% (9,5)19,2% (17,3)
Bremsen2,7% (1,5)5,7% (4,6)8,7% (8,0)12,5% (11,7)
Motor, Abgasanlage und Emissionen0,8% (0,6)1,7% (0,9)3,1% (2,5)5,3% (5,1)
Lenkung0,1% (0,1)1,7% (0,5)4,5% (0,9)6,6% (2,2)
Karosserie, Rahmen und Rost2,4% (0,2)7,5% (0,7)9,7% (2,2)10,2% (5,1)
Gurte und Airbags0,3% (0,1)0,6% (0,3)1,2% (0,6)2,0% (1,5)
Licht und Elektrik (Verschleiß)3,8% (2,4)11,2% (6,3)19,1% (14,2)25,8% (22,2)
Reifen (Verschleiß)3,9% (3,9)6,5% (6,1)8,7% (7,4)10,0% (8,8)
Wischer und Scheibe (Verschleiß)4,2% (2,7)4,9% (3,5)6,0% (5,0)7,2% (6,3)
Sonstiges und Kennzeichen (Verschleiß)0,1% (0,1)0,2% (0,2)0,2% (0,3)0,4% (0,6)

(…) = Klassenmedian, gleiches Alter und gleiche Laufleistung

Checkliste für die Werkstatt vor dem Kauf

Abgeleitet aus den Baugruppen, bei denen dieses Modell ab 100.000 km häufiger durchfällt als seine Klasse, und aus offenen Rückrufen.

  1. Karosserie und Rahmen: Schweller, Hilfsrahmen, Wagenheberaufnahmen und Boden auf Rost und Reparaturspuren prüfen.
  2. Lenkung: Spiel in Lenkgetriebe, Spurstangen und -köpfen, Undichtigkeiten der Servolenkung und Geräusche bei Volleinschlag prüfen.
  3. Fahrwerk und Räder: Querlenker, Buchsen, Traggelenke, Federn und Stoßdämpfer auf Spiel, Risse und Undichtigkeiten prüfen; auf ungleichmäßigen Reifenverschleiß achten.
  4. Rückrufe: Nachweis verlangen, dass offene Rückrufarbeiten für dieses Modell erledigt sind (die Werkstatt prüft per FIN).

Amtliche Rückrufe

Rückrufe der US-Behörde NHTSA und des EU Safety Gate, die dieses Modell nennen. Ob ein bestimmtes Auto betroffen ist, per FIN prüfen.

  • EU Safety GateErnst2023–2026

    There is insufficient clearance (< 10 mm), between the tube of the petrol particulate filter and the terminal protection cap of the 48 V belt-driven starter alternator. In wet conditions, the insufficient clearance and…

    Volltext

    There is insufficient clearance (< 10 mm), between the tube of the petrol particulate filter and the terminal protection cap of the 48 V belt-driven starter alternator. In wet conditions, the insufficient clearance and contact between these components can lead to water infiltration, causing an electric arc which may trigger a thermal event, such as overheating. There is a risk of fire.

    SR/00841/26 ↗
  • EU Safety Gate2023

    The rear axle that does not meet specifications may develop cracks and fracture, leading to reduced vehicle control and increasing the risk of accidents and injuries.

    SR/00174/26 ↗
  • EU Safety GateErnst2022–2025

    The vehicle may have a fuel leak in the high-pressure hose, between the high-pressure pump and the rail, because of loose nuts. This may cause a fire in the vehicle.

    SR/02935/25 ↗
  • EU Safety Gate2015–2024

    The malfunction indicator light (MIL) may fail to illuminate if the diagnostic system of the Selective Catalytic Reduction (SCR) and/or the diesel particulate filter (DPF) malfunctions after a fault code has appeared.…

    Volltext

    The malfunction indicator light (MIL) may fail to illuminate if the diagnostic system of the Selective Catalytic Reduction (SCR) and/or the diesel particulate filter (DPF) malfunctions after a fault code has appeared. This could cause the vehicle to operate without the required warning, and resulting in emissions above the regulatory limits.

    SR/03151/25 ↗
  • EU Safety GateErnst2009–2017

    The airbag may deteriorate over time and if deployed, excessive internal pressure may cause the inflator body to burst and metal fragments could pass through the cushion material causing injury to occupants.

    SR/02977/25 ↗
  • EU Safety Gate2017–2023

    Due to oil carbonisation and high contact pressure, the 7 mm camshaft chain resistance can be reduced. This may cause the camshaft chain to break, leading to an engine failure. This can cause a loss of vehicle's control…

    Volltext

    Due to oil carbonisation and high contact pressure, the 7 mm camshaft chain resistance can be reduced. This may cause the camshaft chain to break, leading to an engine failure. This can cause a loss of vehicle's control and increase the risk of accidents and injuries.

    SR/02655/25 ↗
3 weitere Rückrufe anzeigen
  • EU Safety Gate2024

    The aluminium of the EBS valve block may not fully cast around the valves. This can lead to an internal leak of brake fluid (from one or more of the 12 valve seats) resulting in a reduction of the fluid level and the…

    Volltext

    The aluminium of the EBS valve block may not fully cast around the valves. This can lead to an internal leak of brake fluid (from one or more of the 12 valve seats) resulting in a reduction of the fluid level and the deactivation of stability control due to damage to the pressure sensor. The brake fluid could come into contact with the printed circuit board and result in the deactivation of all control functions (including the anti-lock system and electronic brake force distribution).

    SR/02103/25 ↗
  • EU Safety Gate2022, 2023

    The software supposed to prevent the engine from stopping suddenly and to transmit data to customer service is not working properly. This can lead the ‘Ready’ mode to be unavailable after the vehicle has been started,…

    Volltext

    The software supposed to prevent the engine from stopping suddenly and to transmit data to customer service is not working properly. This can lead the ‘Ready’ mode to be unavailable after the vehicle has been started, to an acceleration power's loss and to the engine suddenly cutting out while driving. This increases the risk of accidents and injuries.

    SR/01423/25 ↗
  • EU Safety Gate2022, 2023

    Due to a faulty software of the electronic engine control unit (ECU), an incorrect value may be given when the data are processed by the vehicle. This may result in nitrogen oxide (NOx) emissions above the regulatory…

    Volltext

    Due to a faulty software of the electronic engine control unit (ECU), an incorrect value may be given when the data are processed by the vehicle. This may result in nitrogen oxide (NOx) emissions above the regulatory limits. Excessive NOx emissions pose a risk to the environment.

    SR/00435/25 ↗