AutoDefects
English

Jaguar XE 2019: reliability

51% more mechanical failures than the class

4,606 MOT tests of Jaguar XE cars first registered in 2019: 6.4% failed for a mechanical defect; the class median at the same age and mileage is 4.3%.

Mechanical failure rate
6.4%
Class median, same age and mileage
4.3%
Failed MOT (any reason)
16.4%
MOT tests
4,606
Recalls
3

What fails, by mileage

MileageTestsMechanical failClass median
0-50k km1,6653.9%2.4%
50-100k km2,3247.2%4.9%
100-150k km51710.1%6.8%
150k+ km10011.0%7.3%

What fails on this year

SystemMechanical fail
Suspension and wheels2.2%
Brakes2.7%
Engine, exhaust and emissions1.4%
Steering0.1%
Body, chassis and corrosion0.2%
Seat belts and airbags0.5%
Lights and electrics (wear)2.9%
Tyres (wear)7.0%
Wipers and windscreen (wear)3.2%
Other and plates (wear)0.2%

Official recalls

Recalls published by the US NHTSA and the EU Safety Gate that name this model. Check by VIN whether a specific car is affected.

  • NHTSA (US)2019, 2020

    Due to wiring damage in the trunk, the rearview camera image may not appear on the display.

    Full text

    Jaguar Land Rover North America, LLC (Jaguar) is recalling certain 2019-2020 Jaguar XE vehicles. Due to wiring damage in the trunk, the rearview camera image may not appear on the display.

    25V017000 ↗
  • NHTSA (US)2019

    Due to wiring damage in the trunk, the rearview camera image may not appear on the display. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 111, "Rear…

    Full text

    Jaguar Land Rover North America, LLC (Jaguar) is recalling certain 2019 Jaguar XE vehicles. Due to wiring damage in the trunk, the rearview camera image may not appear on the display. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 111, "Rear Visibility."

    23V501000 ↗
  • EU Safety Gate2019–2021

    Due to manufacturing defect, the support wire grid between the inner and outer layers of the fuel injector rubber return pipe may not provide sufficient support, which may cause the pipe to bend and break over time. As…

    Full text

    Due to manufacturing defect, the support wire grid between the inner and outer layers of the fuel injector rubber return pipe may not provide sufficient support, which may cause the pipe to bend and break over time. As a result, fuel could leak into the cold side of the motor compartment and onto the road surface, posing a risk to the following traffic.

    A12/01349/21 ↗