AutoDefects
Español

Jaguar XE 2019: fiabilidad

51 % más fallos mecánicos que su clase

4606 inspecciones MOT de Jaguar XE matriculados por primera vez en 2019: el 6,4 % no pasó por un defecto mecánico; la mediana de su clase con la misma edad y kilometraje es del 4,3 %.

Tasa de fallo mecánico
6,4%
Mediana de la clase, misma edad y kilometraje
4,3%
No pasó la MOT (cualquier motivo)
16,4%
inspecciones MOT
4606
Llamadas a revisión
3

Qué falla según el kilometraje

KilometrajeInspeccionesFallo mecánicoMediana de la clase
0-50k km16653,9%2,4%
50-100k km23247,2%4,9%
100-150k km51710,1%6,8%
150k+ km10011,0%7,3%

Qué falla en este año

SistemaFallo mecánico
Suspensión y ruedas2,2%
Frenos2,7%
Motor, escape y emisiones1,4%
Dirección0,1%
Carrocería, bastidor y corrosión0,2%
Cinturones y airbags0,5%
Luces y electricidad (desgaste)2,9%
Neumáticos (desgaste)7,0%
Escobillas y parabrisas (desgaste)3,2%
Otros y matrículas (desgaste)0,2%

Llamadas a revisión oficiales

Campañas publicadas por la NHTSA (EE. UU.) y el EU Safety Gate que citan este modelo. Comprueba por VIN si afecta a un coche concreto.

  • NHTSA (US)2019, 2020

    Due to wiring damage in the trunk, the rearview camera image may not appear on the display.

    Texto completo

    Jaguar Land Rover North America, LLC (Jaguar) is recalling certain 2019-2020 Jaguar XE vehicles. Due to wiring damage in the trunk, the rearview camera image may not appear on the display.

    25V017000 ↗
  • NHTSA (US)2019

    Due to wiring damage in the trunk, the rearview camera image may not appear on the display. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 111, "Rear…

    Texto completo

    Jaguar Land Rover North America, LLC (Jaguar) is recalling certain 2019 Jaguar XE vehicles. Due to wiring damage in the trunk, the rearview camera image may not appear on the display. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 111, "Rear Visibility."

    23V501000 ↗
  • EU Safety Gate2019–2021

    Due to manufacturing defect, the support wire grid between the inner and outer layers of the fuel injector rubber return pipe may not provide sufficient support, which may cause the pipe to bend and break over time. As…

    Texto completo

    Due to manufacturing defect, the support wire grid between the inner and outer layers of the fuel injector rubber return pipe may not provide sufficient support, which may cause the pipe to bend and break over time. As a result, fuel could leak into the cold side of the motor compartment and onto the road surface, posing a risk to the following traffic.

    A12/01349/21 ↗