AutoDefects
Deutsch

Jaguar XE 2019: Zuverlässigkeit

51% mehr technische Mängel als die Klasse

4.606 MOT-Prüfungen von Jaguar XE mit Erstzulassung 2019: 6,4% fielen wegen eines technischen Mangels durch; der Klassenmedian bei gleichem Alter und gleicher Laufleistung liegt bei 4,3%.

Technische Mängelquote
6,4%
Klassenmedian, gleiches Alter und gleiche Laufleistung
4,3%
Durchgefallen (jeder Grund)
16,4%
MOT-Prüfungen
4.606
Rückrufe
3

Was nach Laufleistung ausfällt

LaufleistungPrüfungenTechnische MängelKlassenmedian
0-50k km1.6653,9%2,4%
50-100k km2.3247,2%4,9%
100-150k km51710,1%6,8%
150k+ km10011,0%7,3%

Was bei diesem Baujahr ausfällt

BaugruppeTechnische Mängel
Fahrwerk und Räder2,2%
Bremsen2,7%
Motor, Abgasanlage und Emissionen1,4%
Lenkung0,1%
Karosserie, Rahmen und Rost0,2%
Gurte und Airbags0,5%
Licht und Elektrik (Verschleiß)2,9%
Reifen (Verschleiß)7,0%
Wischer und Scheibe (Verschleiß)3,2%
Sonstiges und Kennzeichen (Verschleiß)0,2%

Amtliche Rückrufe

Rückrufe der US-Behörde NHTSA und des EU Safety Gate, die dieses Modell nennen. Ob ein bestimmtes Auto betroffen ist, per FIN prüfen.

  • NHTSA (US)2019, 2020

    Due to wiring damage in the trunk, the rearview camera image may not appear on the display.

    Volltext

    Jaguar Land Rover North America, LLC (Jaguar) is recalling certain 2019-2020 Jaguar XE vehicles. Due to wiring damage in the trunk, the rearview camera image may not appear on the display.

    25V017000 ↗
  • NHTSA (US)2019

    Due to wiring damage in the trunk, the rearview camera image may not appear on the display. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 111, "Rear…

    Volltext

    Jaguar Land Rover North America, LLC (Jaguar) is recalling certain 2019 Jaguar XE vehicles. Due to wiring damage in the trunk, the rearview camera image may not appear on the display. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 111, "Rear Visibility."

    23V501000 ↗
  • EU Safety Gate2019–2021

    Due to manufacturing defect, the support wire grid between the inner and outer layers of the fuel injector rubber return pipe may not provide sufficient support, which may cause the pipe to bend and break over time. As…

    Volltext

    Due to manufacturing defect, the support wire grid between the inner and outer layers of the fuel injector rubber return pipe may not provide sufficient support, which may cause the pipe to bend and break over time. As a result, fuel could leak into the cold side of the motor compartment and onto the road surface, posing a risk to the following traffic.

    A12/01349/21 ↗