Toyota Yaris 2015: надійність
30 767 техоглядів Toyota Yaris першої реєстрації 2015 року: 6,4% не пройшли через механічний дефект; медіана класу того ж віку й пробігу — 16,4%.
- Відмови через механіку
- 6,4%
- Медіана класу, той самий вік і пробіг
- 16,4%
- Не пройшли MOT (будь-яка причина)
- 19,6%
- техоглядів MOT
- 30 767
- Відкликання
- 9
Що ламається залежно від пробігу
| Пробіг | Техогляди | Механічні відмови | Медіана класу |
|---|---|---|---|
| 0-50k km | 5 572 | 2,9% | 7,9% |
| 50-100k km | 15 011 | 5,4% | 14,8% |
| 100-150k km | 7 685 | 8,8% | 22,0% |
| 150k+ km | 2 499 | 12,2% | 27,6% |
Що ламається в цьому році випуску
Офіційні відкликання
Відкликання, опубліковані NHTSA (США) та EU Safety Gate, у яких названо цю модель. Чи стосується це конкретного авто, перевіряйте за VIN.
The gas generator on the driver side frontal airbag may be defective. Metal fragments can be released when the airbag is activated, causing injury to the occupants.
A12/0816/19 ↗The wire harnesses of the side airbag sensors could crack and the wires may corrode. In the event of a crash the front seat airbags and the curtain shield airbags may not deploy, increasing the risk of injury.
A12/0734/19 ↗The wire harnesses for the side air bag sensors located within the front doors may crack and corrode, possibly causing the non-deployment or improper deployment of the front seat side air bags and the curtain shield air…
19V319000 ↗Повний текст
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2015-2017 Yaris vehicles. The wire harnesses for the side air bag sensors located within the front doors may crack and corrode, possibly causing the non-deployment or improper deployment of the front seat side air bags and the curtain shield air bags.
null The mounting bearings of the front shock absorbers (struts) can be damaged if the strut is subject to a high load (e.g. a large bump), which may cause the upper side of the strut rod to separate, causing a loss of…
A12/0703/16 ↗Повний текст
null The mounting bearings of the front shock absorbers (struts) can be damaged if the strut is subject to a high load (e.g. a large bump), which may cause the upper side of the strut rod to separate, causing a loss of stability.
The front strut mounting bearings can be damaged when a high load is applied to the strut, such as driving over a large bump.
16V367000 ↗Повний текст
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain model year 2015 Yaris vehicles manufactured January 13, 2015, to February 27, 2015. The front strut mounting bearings can be damaged when a high load is applied to the strut, such as driving over a large bump.
null The anchor plate for the rear seatbelts may have a sharp edge. In the event of a collision, there is a possibility that the webbing for the buckle part of the seatbelt could consequently become cut and separate at…
A12/0510/16 ↗Повний текст
null The anchor plate for the rear seatbelts may have a sharp edge. In the event of a collision, there is a possibility that the webbing for the buckle part of the seatbelt could consequently become cut and separate at the anchor plate. If this occurred, the occupant would not be properly restrained, increasing the risk of injury.
Показати ще 3 відкликань
The affected vehicles may have been manufactured with a roof headliner that does not provide the proper occupant protection in the event of a crash. As such, these vehicles fail to comply with the requirements of…
15V134000 ↗Повний текст
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain model year 2012-2015 Yaris vehicles manufactured August 31, 2011, to February 9, 2015, and sold or registered in Puerto Rico. The affected vehicles may have been manufactured with a roof headliner that does not provide the proper occupant protection in the event of a crash. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) No. 201, " Occupant Protection in Interior Impact."
null There is a possibility that one or more of the rear axle bearing bolts could have been tightened insufficiently during the manufacturing process. In this condition, the bolt(s) could become loose during vehicle…
A12/0276/15 ↗Повний текст
null There is a possibility that one or more of the rear axle bearing bolts could have been tightened insufficiently during the manufacturing process. In this condition, the bolt(s) could become loose during vehicle operation and could eventually detach. The detached bolt(s) could damage rear brake components during rotation, resulting in a reduction of brake performance or a potential wheel lock up, which could increase the risk of a crash.
The affected vehicles may have improperly tightened rear axle bearing bolts.
15V098000 ↗Повний текст
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain model year 2015 Yaris vehicles manufactured September 8, 2014, to January 9, 2015. The affected vehicles may have improperly tightened rear axle bearing bolts.