AutoDefects
Deutsch

Toyota Yaris 2015: Zuverlässigkeit

61% weniger technische Mängel als die Klasse

30.767 MOT-Prüfungen von Toyota Yaris mit Erstzulassung 2015: 6,4% fielen wegen eines technischen Mangels durch; der Klassenmedian bei gleichem Alter und gleicher Laufleistung liegt bei 16,4%.

Technische Mängelquote
6,4%
Klassenmedian, gleiches Alter und gleiche Laufleistung
16,4%
Durchgefallen (jeder Grund)
19,6%
MOT-Prüfungen
30.767
Rückrufe
9

Was nach Laufleistung ausfällt

LaufleistungPrüfungenTechnische MängelKlassenmedian
0-50k km5.5722,9%7,9%
50-100k km15.0115,4%14,8%
100-150k km7.6858,8%22,0%
150k+ km2.49912,2%27,6%

Was bei diesem Baujahr ausfällt

BaugruppeTechnische Mängel
Fahrwerk und Räder2,5%
Bremsen3,5%
Motor, Abgasanlage und Emissionen0,3%
Lenkung0,1%
Karosserie, Rahmen und Rost0,5%
Gurte und Airbags0,2%
Licht und Elektrik (Verschleiß)8,3%
Reifen (Verschleiß)5,5%
Wischer und Scheibe (Verschleiß)4,7%
Sonstiges und Kennzeichen (Verschleiß)0,1%

Amtliche Rückrufe

Rückrufe der US-Behörde NHTSA und des EU Safety Gate, die dieses Modell nennen. Ob ein bestimmtes Auto betroffen ist, per FIN prüfen.

  • EU Safety GateErnst2015–2018

    The gas generator on the driver side frontal airbag may be defective. Metal fragments can be released when the airbag is activated, causing injury to the occupants.

    A12/0816/19 ↗
  • EU Safety GateErnst2014–2017

    The wire harnesses of the side airbag sensors could crack and the wires may corrode. In the event of a crash the front seat airbags and the curtain shield airbags may not deploy, increasing the risk of injury.

    A12/0734/19 ↗
  • NHTSA (US)Ernst2015–2017

    The wire harnesses for the side air bag sensors located within the front doors may crack and corrode, possibly causing the non-deployment or improper deployment of the front seat side air bags and the curtain shield air…

    Volltext

    Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2015-2017 Yaris vehicles. The wire harnesses for the side air bag sensors located within the front doors may crack and corrode, possibly causing the non-deployment or improper deployment of the front seat side air bags and the curtain shield air bags.

    19V319000 ↗
  • EU Safety Gate2015, 2016

    null The mounting bearings of the front shock absorbers (struts) can be damaged if the strut is subject to a high load (e.g. a large bump), which may cause the upper side of the strut rod to separate, causing a loss of…

    Volltext

    null The mounting bearings of the front shock absorbers (struts) can be damaged if the strut is subject to a high load (e.g. a large bump), which may cause the upper side of the strut rod to separate, causing a loss of stability.

    A12/0703/16 ↗
  • NHTSA (US)2015

    The front strut mounting bearings can be damaged when a high load is applied to the strut, such as driving over a large bump.

    Volltext

    Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain model year 2015 Yaris vehicles manufactured January 13, 2015, to February 27, 2015. The front strut mounting bearings can be damaged when a high load is applied to the strut, such as driving over a large bump.

    16V367000 ↗
  • EU Safety GateErnst2015, 2016

    null The anchor plate for the rear seatbelts may have a sharp edge. In the event of a collision, there is a possibility that the webbing for the buckle part of the seatbelt could consequently become cut and separate at…

    Volltext

    null The anchor plate for the rear seatbelts may have a sharp edge. In the event of a collision, there is a possibility that the webbing for the buckle part of the seatbelt could consequently become cut and separate at the anchor plate. If this occurred, the occupant would not be properly restrained, increasing the risk of injury.

    A12/0510/16 ↗
3 weitere Rückrufe anzeigen
  • NHTSA (US)2012–2015

    The affected vehicles may have been manufactured with a roof headliner that does not provide the proper occupant protection in the event of a crash. As such, these vehicles fail to comply with the requirements of…

    Volltext

    Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain model year 2012-2015 Yaris vehicles manufactured August 31, 2011, to February 9, 2015, and sold or registered in Puerto Rico. The affected vehicles may have been manufactured with a roof headliner that does not provide the proper occupant protection in the event of a crash. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) No. 201, " Occupant Protection in Interior Impact."

    15V134000 ↗
  • EU Safety Gate2014, 2015

    null There is a possibility that one or more of the rear axle bearing bolts could have been tightened insufficiently during the manufacturing process. In this condition, the bolt(s) could become loose during vehicle…

    Volltext

    null There is a possibility that one or more of the rear axle bearing bolts could have been tightened insufficiently during the manufacturing process. In this condition, the bolt(s) could become loose during vehicle operation and could eventually detach. The detached bolt(s) could damage rear brake components during rotation, resulting in a reduction of brake performance or a potential wheel lock up, which could increase the risk of a crash.

    A12/0276/15 ↗
  • NHTSA (US)2015

    The affected vehicles may have improperly tightened rear axle bearing bolts.

    Volltext

    Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain model year 2015 Yaris vehicles manufactured September 8, 2014, to January 9, 2015. The affected vehicles may have improperly tightened rear axle bearing bolts.

    15V098000 ↗