Toyota Yaris 2015: niezawodność
30 767 badań MOT egzemplarzy Toyota Yaris zarejestrowanych po raz pierwszy w 2015: 6,4% nie przeszło z powodu usterki mechanicznej; mediana klasy w tym samym wieku i z tym samym przebiegiem to 16,4%.
- Usterki mechaniczne
- 6,4%
- Mediana klasy, ten sam wiek i przebieg
- 16,4%
- Negatywne badanie (dowolny powód)
- 19,6%
- badań MOT
- 30 767
- Akcje przywoławcze
- 9
Co się psuje w zależności od przebiegu
| Przebieg | Badania | Usterki mechaniczne | Mediana klasy |
|---|---|---|---|
| 0-50k km | 5572 | 2,9% | 7,9% |
| 50-100k km | 15 011 | 5,4% | 14,8% |
| 100-150k km | 7685 | 8,8% | 22,0% |
| 150k+ km | 2499 | 12,2% | 27,6% |
Co się psuje w tym roczniku
Oficjalne akcje przywoławcze
Akcje opublikowane przez NHTSA (USA) i EU Safety Gate, w których wymieniono ten model. Czy dotyczą konkretnego auta, sprawdź po VIN.
The gas generator on the driver side frontal airbag may be defective. Metal fragments can be released when the airbag is activated, causing injury to the occupants.
A12/0816/19 ↗The wire harnesses of the side airbag sensors could crack and the wires may corrode. In the event of a crash the front seat airbags and the curtain shield airbags may not deploy, increasing the risk of injury.
A12/0734/19 ↗The wire harnesses for the side air bag sensors located within the front doors may crack and corrode, possibly causing the non-deployment or improper deployment of the front seat side air bags and the curtain shield air…
19V319000 ↗Pełny tekst
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2015-2017 Yaris vehicles. The wire harnesses for the side air bag sensors located within the front doors may crack and corrode, possibly causing the non-deployment or improper deployment of the front seat side air bags and the curtain shield air bags.
null The mounting bearings of the front shock absorbers (struts) can be damaged if the strut is subject to a high load (e.g. a large bump), which may cause the upper side of the strut rod to separate, causing a loss of…
A12/0703/16 ↗Pełny tekst
null The mounting bearings of the front shock absorbers (struts) can be damaged if the strut is subject to a high load (e.g. a large bump), which may cause the upper side of the strut rod to separate, causing a loss of stability.
The front strut mounting bearings can be damaged when a high load is applied to the strut, such as driving over a large bump.
16V367000 ↗Pełny tekst
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain model year 2015 Yaris vehicles manufactured January 13, 2015, to February 27, 2015. The front strut mounting bearings can be damaged when a high load is applied to the strut, such as driving over a large bump.
null The anchor plate for the rear seatbelts may have a sharp edge. In the event of a collision, there is a possibility that the webbing for the buckle part of the seatbelt could consequently become cut and separate at…
A12/0510/16 ↗Pełny tekst
null The anchor plate for the rear seatbelts may have a sharp edge. In the event of a collision, there is a possibility that the webbing for the buckle part of the seatbelt could consequently become cut and separate at the anchor plate. If this occurred, the occupant would not be properly restrained, increasing the risk of injury.
Pokaż jeszcze 3 akcji
The affected vehicles may have been manufactured with a roof headliner that does not provide the proper occupant protection in the event of a crash. As such, these vehicles fail to comply with the requirements of…
15V134000 ↗Pełny tekst
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain model year 2012-2015 Yaris vehicles manufactured August 31, 2011, to February 9, 2015, and sold or registered in Puerto Rico. The affected vehicles may have been manufactured with a roof headliner that does not provide the proper occupant protection in the event of a crash. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) No. 201, " Occupant Protection in Interior Impact."
null There is a possibility that one or more of the rear axle bearing bolts could have been tightened insufficiently during the manufacturing process. In this condition, the bolt(s) could become loose during vehicle…
A12/0276/15 ↗Pełny tekst
null There is a possibility that one or more of the rear axle bearing bolts could have been tightened insufficiently during the manufacturing process. In this condition, the bolt(s) could become loose during vehicle operation and could eventually detach. The detached bolt(s) could damage rear brake components during rotation, resulting in a reduction of brake performance or a potential wheel lock up, which could increase the risk of a crash.
The affected vehicles may have improperly tightened rear axle bearing bolts.
15V098000 ↗Pełny tekst
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain model year 2015 Yaris vehicles manufactured September 8, 2014, to January 9, 2015. The affected vehicles may have improperly tightened rear axle bearing bolts.