Пікапи
Надійність Nissan Navara
За 73 320 британськими техоглядами MOT 23,7% автомобілів Nissan Navara не пройшли через механічний або кузовний дефект. Медіана для пікапа того ж віку й пробігу: 20,8%.
- Найкращі роки
- —
- Роки з найбільшою кількістю відмов
- 2017, 2018, 2019
- Слабке місце на великому пробігу
- Кермове керування, Двигун, вихлоп і викиди
- Офіційні відкликання
- 9 відкликань, серйозних: 6
- Відмови через механіку
- 23,7%
- Медіана класу, той самий вік і пробіг
- 20,8%
- техоглядів MOT
- 73 320
- Скарги власників у США
- 0
Результати техоглядів за роками
Уся флотилія цієї моделі на техоглядах кожного року порівняно з класом того ж віку й пробігу. Видно, чи тримає модель позицію з віком.
| Рік техогляду | Техогляди | Механічні відмови | Медіана класу | Усі відмови |
|---|---|---|---|---|
| 2024 | 73 320 | 23,7% | 20,8% | 31,9% |
| 2023 | 71 282 | 24,2% | 21,6% | 32,8% |
Відсоток відмов за роком першої реєстрації
Частка механічних відмов на техогляді 2024 року за роком першої реєстрації авто порівняно з медіаною класу того ж віку й пробігу.
| Рік | Техогляди | Механічні відмови | Медіана класу | Усі відмови | Відкликання |
|---|---|---|---|---|---|
| 2021 | 7 049 | 7,6% | 7,6% | 15,5% | 0 |
| 2020 | 4 452 | 11,9% | 10,5% | 19,7% | 0 |
| 2019 | 7 480 | 14,7% | 12,0% | 21,6% | 0 |
| 2018 | 7 923 | 20,4% | 14,4% | 26,9% | 1 |
| 2017 | 8 782 | 24,2% | 15,8% | 31,0% | 1 |
| 2016 | 7 642 | 19,4% | 19,1% | 27,7% | 2 |
| 2015 | 3 928 | 26,2% | 23,2% | 37,0% | 2 |
| 2014 | 3 539 | 28,4% | 26,3% | 39,1% | 0 |
| 2013 | 3 451 | 31,1% | 28,1% | 41,1% | 2 |
| 2012 | 3 311 | 36,8% | 31,0% | 46,5% | 3 |
| 2011 | 3 924 | 35,5% | 33,8% | 43,9% | 3 |
| 2010 | 1 865 | 34,8% | 34,5% | 44,5% | 3 |
| 2009 | 1 736 | 36,6% | 34,8% | 45,4% | 3 |
| 2008 | 1 740 | 36,4% | 36,1% | 46,2% | 2 |
| 2007 | 2 201 | 37,6% | 35,0% | 45,7% | 2 |
| 2006 | 1 849 | 36,7% | 36,9% | 44,5% | 2 |
| 2005 | 1 256 | 36,7% | 34,9% | 46,2% | 2 |
| 2004 | 744 | 35,8% | 34,6% | 42,5% | 2 |
Що ламається залежно від пробігу
Частка техоглядів, не пройдених через кожну систему. Витратні елементи (лампи, шини, щітки, номери) не враховуються в індексі надійності.
(…) = Медіана класу, той самий вік і пробіг
Чекліст для СТО перед купівлею
Складено із систем, де ця модель ламається частіше за свій клас при пробігу від 100 000 км, і з відкритих відкликань.
- Кермо: перевірте люфт рейки, кермових тяг і наконечників, підтікання підсилювача й шум у крайніх положеннях.
- Двигун і вихлоп: шукайте підтікання оливи й антифризу, прогари й корозію вихлопу, помилки на панелі; для дизеля — стан сажового фільтра (DPF) і EGR, димність.
- Відкликання: серйозних відкликань для моделі — 5. Попросіть підтвердження, що роботи виконано
- A12/0089/19 · 2004–2012 · A defect in the gas generator of the passenger airbag causes uncontrolled inflation and the release of metal fragments when the airbag is…
- A12/1451/17 · 2004–2012 · null In the event of deployment of the passenger airbag, the inflator body of the airbag could shatter and release metal fragments into the…
- A12/1685/16 · 2009–2012 · null In the event of the passenger airbag being deployed, the casing of the inflator may burst causing injuries to the passengers.
- A12/0717/15 · · null A potential air leak on some passenger airbag inflators may allow moisture to enter the airbag inflator causing the propellant in the…
- A12/1827/13 · 2013 · null The left hand side and the right hand side seat belts may have been swapped. This incorrect installation of the seat belts may…
Перевірте конкретне авто за VIN на офіційних сайтах: NHTSA (US) · DVSA (UK)
Офіційні відкликання
Відкликання, опубліковані NHTSA (США) та EU Safety Gate, у яких названо цю модель. Чи стосується це конкретного авто, перевіряйте за VIN.
The child lock on the rear doors could be defective.As a result, it might be possible to open the door even when the child lock is activated, increasing the risk of an accident.
A12/01207/20 ↗A defect in the gas generator of the passenger airbag causes uncontrolled inflation and the release of metal fragments when the airbag is activated. This can cause injury to the occupants of the vehicle.
A12/0089/19 ↗null In the event of deployment of the passenger airbag, the inflator body of the airbag could shatter and release metal fragments into the vehicle cabin causing injuries to the occupants.
A12/1451/17 ↗null The upper brake light on the hardtop may not light up when the engine is starting and the vehicle is about to move off.
A12/1765/16 ↗null In the event of the passenger airbag being deployed, the casing of the inflator may burst causing injuries to the passengers.
A12/1685/16 ↗null A potential air leak on some passenger airbag inflators may allow moisture to enter the airbag inflator causing the propellant in the inflator units to deteriorate. Deterioration of the propellant may create…
A12/0717/15 ↗Повний текст
null A potential air leak on some passenger airbag inflators may allow moisture to enter the airbag inflator causing the propellant in the inflator units to deteriorate. Deterioration of the propellant may create excessive pressure and may result in separation of the airbag housing.
Показати ще 3 відкликань
null The left hand side and the right hand side seat belts may have been swapped. This incorrect installation of the seat belts may potentially affect restraint performance.
A12/1827/13 ↗null The front suspension lower ball joint may disconnect from the lower link under some driving conditions, such as when driving over potholes or kerb-stones, potentially affecting the steering control and the braking…
A12/1551/13 ↗Повний текст
null The front suspension lower ball joint may disconnect from the lower link under some driving conditions, such as when driving over potholes or kerb-stones, potentially affecting the steering control and the braking of the vehicle.
null The front passenger airbag inflators may have been manufactured out of specification. This could create excessive pressure within the inflator during airbag deployment and may result in separation of the airbag…
A12/0479/13 ↗Повний текст
null The front passenger airbag inflators may have been manufactured out of specification. This could create excessive pressure within the inflator during airbag deployment and may result in separation of the airbag housing.