Pick-upy
Nissan Navara — niezawodność
W 73 320 brytyjskich badaniach MOT 23,7% egzemplarzy Nissan Navara nie przeszło z powodu usterki mechanicznej lub nadwozia. Mediana dla pick-upa w tym samym wieku i z tym samym przebiegiem: 20,8%.
- Najlepsze roczniki
- —
- Roczniki z największą liczbą usterek
- 2017, 2018, 2019
- Słaby punkt przy dużym przebiegu
- Układ kierowniczy, Silnik, wydech i emisja
- Oficjalne akcje przywoławcze
- 9 akcji, poważnych: 6
- Usterki mechaniczne
- 23,7%
- Mediana klasy, ten sam wiek i przebieg
- 20,8%
- badań MOT
- 73 320
- Skargi właścicieli w USA
- 0
Wyniki badań według roku
Wszystkie egzemplarze modelu na badaniach w danym roku wobec klasy w tym samym wieku i z tym samym przebiegiem. Widać, czy model utrzymuje pozycję z wiekiem.
| Rok badania | Badania | Usterki mechaniczne | Mediana klasy | Wszystkie usterki |
|---|---|---|---|---|
| 2024 | 73 320 | 23,7% | 20,8% | 31,9% |
| 2023 | 71 282 | 24,2% | 21,6% | 32,8% |
Odsetek usterek według roku pierwszej rejestracji
Odsetek usterek mechanicznych na badaniu MOT w 2024 r. według roku pierwszej rejestracji, wobec mediany klasy w tym samym wieku i z tym samym przebiegiem.
| Rok | Badania | Usterki mechaniczne | Mediana klasy | Wszystkie usterki | Akcje |
|---|---|---|---|---|---|
| 2021 | 7049 | 7,6% | 7,6% | 15,5% | 0 |
| 2020 | 4452 | 11,9% | 10,5% | 19,7% | 0 |
| 2019 | 7480 | 14,7% | 12,0% | 21,6% | 0 |
| 2018 | 7923 | 20,4% | 14,4% | 26,9% | 1 |
| 2017 | 8782 | 24,2% | 15,8% | 31,0% | 1 |
| 2016 | 7642 | 19,4% | 19,1% | 27,7% | 2 |
| 2015 | 3928 | 26,2% | 23,2% | 37,0% | 2 |
| 2014 | 3539 | 28,4% | 26,3% | 39,1% | 0 |
| 2013 | 3451 | 31,1% | 28,1% | 41,1% | 2 |
| 2012 | 3311 | 36,8% | 31,0% | 46,5% | 3 |
| 2011 | 3924 | 35,5% | 33,8% | 43,9% | 3 |
| 2010 | 1865 | 34,8% | 34,5% | 44,5% | 3 |
| 2009 | 1736 | 36,6% | 34,8% | 45,4% | 3 |
| 2008 | 1740 | 36,4% | 36,1% | 46,2% | 2 |
| 2007 | 2201 | 37,6% | 35,0% | 45,7% | 2 |
| 2006 | 1849 | 36,7% | 36,9% | 44,5% | 2 |
| 2005 | 1256 | 36,7% | 34,9% | 46,2% | 2 |
| 2004 | 744 | 35,8% | 34,6% | 42,5% | 2 |
Co się psuje w zależności od przebiegu
Odsetek badań niezaliczonych z powodu danego układu. Elementy eksploatacyjne (żarówki, opony, wycieraczki, tablice) nie wpływają na wskaźnik niezawodności.
(…) = Mediana klasy, ten sam wiek i przebieg
Lista kontrolna dla mechanika przed zakupem
Na podstawie układów, w których ten model psuje się częściej niż jego klasa przy przebiegu od 100 000 km, oraz otwartych akcji przywoławczych.
- Układ kierowniczy: sprawdź luzy przekładni, drążków i końcówek, wycieki wspomagania i hałas przy pełnym skręcie.
- Silnik i wydech: szukaj wycieków oleju i płynu chłodniczego, nieszczelności i korozji wydechu, kontrolek; w dieslu stan DPF/EGR i dymienie.
- Akcje przywoławcze: poważnych akcji dla modelu — 5. Poproś o potwierdzenie wykonania napraw
- A12/0089/19 · 2004–2012 · A defect in the gas generator of the passenger airbag causes uncontrolled inflation and the release of metal fragments when the airbag is…
- A12/1451/17 · 2004–2012 · null In the event of deployment of the passenger airbag, the inflator body of the airbag could shatter and release metal fragments into the…
- A12/1685/16 · 2009–2012 · null In the event of the passenger airbag being deployed, the casing of the inflator may burst causing injuries to the passengers.
- A12/0717/15 · · null A potential air leak on some passenger airbag inflators may allow moisture to enter the airbag inflator causing the propellant in the…
- A12/1827/13 · 2013 · null The left hand side and the right hand side seat belts may have been swapped. This incorrect installation of the seat belts may…
Sprawdź konkretne auto po VIN na oficjalnych stronach: NHTSA (US) · DVSA (UK)
Oficjalne akcje przywoławcze
Akcje opublikowane przez NHTSA (USA) i EU Safety Gate, w których wymieniono ten model. Czy dotyczą konkretnego auta, sprawdź po VIN.
The child lock on the rear doors could be defective.As a result, it might be possible to open the door even when the child lock is activated, increasing the risk of an accident.
A12/01207/20 ↗A defect in the gas generator of the passenger airbag causes uncontrolled inflation and the release of metal fragments when the airbag is activated. This can cause injury to the occupants of the vehicle.
A12/0089/19 ↗null In the event of deployment of the passenger airbag, the inflator body of the airbag could shatter and release metal fragments into the vehicle cabin causing injuries to the occupants.
A12/1451/17 ↗null The upper brake light on the hardtop may not light up when the engine is starting and the vehicle is about to move off.
A12/1765/16 ↗null In the event of the passenger airbag being deployed, the casing of the inflator may burst causing injuries to the passengers.
A12/1685/16 ↗null A potential air leak on some passenger airbag inflators may allow moisture to enter the airbag inflator causing the propellant in the inflator units to deteriorate. Deterioration of the propellant may create…
A12/0717/15 ↗Pełny tekst
null A potential air leak on some passenger airbag inflators may allow moisture to enter the airbag inflator causing the propellant in the inflator units to deteriorate. Deterioration of the propellant may create excessive pressure and may result in separation of the airbag housing.
Pokaż jeszcze 3 akcji
null The left hand side and the right hand side seat belts may have been swapped. This incorrect installation of the seat belts may potentially affect restraint performance.
A12/1827/13 ↗null The front suspension lower ball joint may disconnect from the lower link under some driving conditions, such as when driving over potholes or kerb-stones, potentially affecting the steering control and the braking…
A12/1551/13 ↗Pełny tekst
null The front suspension lower ball joint may disconnect from the lower link under some driving conditions, such as when driving over potholes or kerb-stones, potentially affecting the steering control and the braking of the vehicle.
null The front passenger airbag inflators may have been manufactured out of specification. This could create excessive pressure within the inflator during airbag deployment and may result in separation of the airbag…
A12/0479/13 ↗Pełny tekst
null The front passenger airbag inflators may have been manufactured out of specification. This could create excessive pressure within the inflator during airbag deployment and may result in separation of the airbag housing.