AutoDefects
Polski

Suzuki Jimny 2018: niezawodność

o 169% więcej usterek mechanicznych niż w klasie

496 badań MOT egzemplarzy Suzuki Jimny zarejestrowanych po raz pierwszy w 2018: 12,7% nie przeszło z powodu usterki mechanicznej; mediana klasy w tym samym wieku i z tym samym przebiegiem to 4,7%.

Usterki mechaniczne
12,7%
Mediana klasy, ten sam wiek i przebieg
4,7%
Negatywne badanie (dowolny powód)
19,8%
badań MOT
496
Akcje przywoławcze
2

Co się psuje w zależności od przebiegu

PrzebiegBadaniaUsterki mechaniczneMediana klasy
0-50k km3159,5%2,9%
50-100k km15617,3%6,9%
100-150k km2123,8%13,2%
150k+ km425,0%17,8%

Co się psuje w tym roczniku

UkładUsterki mechaniczne
Zawieszenie i koła11,5%
Hamulce1,4%
Silnik, wydech i emisja0,2%
Układ kierowniczy0,0%
Nadwozie, podwozie i korozja0,2%
Pasy i poduszki powietrzne0,0%
Oświetlenie i elektryka (eksploatacja)4,2%
Opony (eksploatacja)2,2%
Wycieraczki i szyba (eksploatacja)3,6%
Inne i tablice (eksploatacja)0,2%

Oficjalne akcje przywoławcze

Akcje opublikowane przez NHTSA (USA) i EU Safety Gate, w których wymieniono ten model. Czy dotyczą konkretnego auta, sprawdź po VIN.

  • EU Safety Gate2018, 2019

    The resinous material of the fuel pump is not dense enough, can deform and come into contact with the pump housing. This can cause the pump to fail, potentially resulting in the engine stalling and increasing the risk…

    Pełny tekst

    The resinous material of the fuel pump is not dense enough, can deform and come into contact with the pump housing. This can cause the pump to fail, potentially resulting in the engine stalling and increasing the risk of accidents and injuries.

    A12/00885/24 ↗
  • EU Safety Gate2018

    The fuel feeding impeller in the fuel pump, which is made of resin material, may be swollen and deformed due to the insufficient material density caused by the improper injection molding process. Consequently, the…

    Pełny tekst

    The fuel feeding impeller in the fuel pump, which is made of resin material, may be swollen and deformed due to the insufficient material density caused by the improper injection molding process. Consequently, the impeller may interfere with the fuel pump housing, resulting in the fuel pump malfunction. As a result, the engine could stop while driving, increasing the risk of an accident.

    A12/00956/21 ↗