AutoDefects
Polski

Peugeot Expert / Traveller 2013: niezawodność

o 9% więcej usterek mechanicznych niż w klasie

1985 badań MOT egzemplarzy Peugeot Expert / Traveller zarejestrowanych po raz pierwszy w 2013: 33,5% nie przeszło z powodu usterki mechanicznej; mediana klasy w tym samym wieku i z tym samym przebiegiem to 30,7%.

Usterki mechaniczne
33,5%
Mediana klasy, ten sam wiek i przebieg
30,7%
Negatywne badanie (dowolny powód)
47,1%
badań MOT
1985
Akcje przywoławcze
7

Co się psuje w zależności od przebiegu

PrzebiegBadaniaUsterki mechaniczneMediana klasy
0-50k km3625,0%12,0%
50-100k km15723,6%21,2%
100-150k km35428,8%27,2%
150k+ km143835,9%33,0%

Co się psuje w tym roczniku

UkładUsterki mechaniczne
Zawieszenie i koła12,4%
Hamulce11,3%
Silnik, wydech i emisja6,2%
Układ kierowniczy2,4%
Nadwozie, podwozie i korozja18,2%
Pasy i poduszki powietrzne1,6%
Oświetlenie i elektryka (eksploatacja)27,5%
Opony (eksploatacja)6,9%
Wycieraczki i szyba (eksploatacja)8,6%
Inne i tablice (eksploatacja)0,7%

Oficjalne akcje przywoławcze

Akcje opublikowane przez NHTSA (USA) i EU Safety Gate, w których wymieniono ten model. Czy dotyczą konkretnego auta, sprawdź po VIN.

  • EU Safety Gate2008–2023

    The software supposed to prevent the engine from stopping suddenly and to transmit data to customer service is not working properly. This can lead the ‘Ready’ mode to be unavailable after the vehicle has been started,…

    Pełny tekst

    The software supposed to prevent the engine from stopping suddenly and to transmit data to customer service is not working properly. This can lead the ‘Ready’ mode to be unavailable after the vehicle has been started, to an acceleration power's loss and to the engine suddenly cutting out while driving. This increases the risk of accidents and injuries.

    SR/01450/25 ↗
  • EU Safety Gate2008–2022

    A software error in the engine control unit prevents the malfunction indicator light (MIL) from switching on if the urea injector stops working. This can lead to higher emissions and poses a risk to the environment.

    A12/01870/23 ↗
  • EU Safety Gate2008–2018

    The teeth of the timing belt may wear off prematurely due to excessive dynamic tension in dusty conditions. As a result, the engine may stall at high engine speeds and not being able to restart, increasing the risk of…

    Pełny tekst

    The teeth of the timing belt may wear off prematurely due to excessive dynamic tension in dusty conditions. As a result, the engine may stall at high engine speeds and not being able to restart, increasing the risk of an accident. The product does not meet the requirements laid down in the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.

    A12/01184/21 ↗
  • EU Safety Gate2008–2016

    null A problem with a component of the gearbox actuator could prevent gear changing or cause the driver to change to the wrong gear. This could lead to the vehicle moving in the opposite direction to that intended by…

    Pełny tekst

    null A problem with a component of the gearbox actuator could prevent gear changing or cause the driver to change to the wrong gear. This could lead to the vehicle moving in the opposite direction to that intended by the driver.

    A12/0479/17 ↗
  • EU Safety Gate2013–2016

    null Possible incorrect positioning of a fuel pipe seal in the filler cap area could lead to loss of fuel when the tank is filled completely or in the event that the vehicle overturns.

    A12/0207/17 ↗
  • EU Safety Gate2012–2014

    null In the case of negative exterior temperatures, and after repeated activation of the fuel heater, an electric connection on the cover of the fuel heater can overheat. This can cause the cover to melt, allowing air…

    Pełny tekst

    null In the case of negative exterior temperatures, and after repeated activation of the fuel heater, an electric connection on the cover of the fuel heater can overheat. This can cause the cover to melt, allowing air to enter the fuel system which could lead to stalling of the engine and loss of control of the car.

    A12/1317/15 ↗
Pokaż jeszcze 1 akcji
  • EU Safety GatePoważne2010–2014

    null Fuel leakage at the junction between the fuel return pipe and the injectors on the engine, caused by progressive wear of the return pipe, can lead to the risk of fire.

    A12/2132/14 ↗