AutoDefects
Deutsch

Peugeot Expert / Traveller 2013: Zuverlässigkeit

9% mehr technische Mängel als die Klasse

1.985 MOT-Prüfungen von Peugeot Expert / Traveller mit Erstzulassung 2013: 33,5% fielen wegen eines technischen Mangels durch; der Klassenmedian bei gleichem Alter und gleicher Laufleistung liegt bei 30,7%.

Technische Mängelquote
33,5%
Klassenmedian, gleiches Alter und gleiche Laufleistung
30,7%
Durchgefallen (jeder Grund)
47,1%
MOT-Prüfungen
1.985
Rückrufe
7

Was nach Laufleistung ausfällt

LaufleistungPrüfungenTechnische MängelKlassenmedian
0-50k km3625,0%12,0%
50-100k km15723,6%21,2%
100-150k km35428,8%27,2%
150k+ km1.43835,9%33,0%

Was bei diesem Baujahr ausfällt

BaugruppeTechnische Mängel
Fahrwerk und Räder12,4%
Bremsen11,3%
Motor, Abgasanlage und Emissionen6,2%
Lenkung2,4%
Karosserie, Rahmen und Rost18,2%
Gurte und Airbags1,6%
Licht und Elektrik (Verschleiß)27,5%
Reifen (Verschleiß)6,9%
Wischer und Scheibe (Verschleiß)8,6%
Sonstiges und Kennzeichen (Verschleiß)0,7%

Amtliche Rückrufe

Rückrufe der US-Behörde NHTSA und des EU Safety Gate, die dieses Modell nennen. Ob ein bestimmtes Auto betroffen ist, per FIN prüfen.

  • EU Safety Gate2008–2023

    The software supposed to prevent the engine from stopping suddenly and to transmit data to customer service is not working properly. This can lead the ‘Ready’ mode to be unavailable after the vehicle has been started,…

    Volltext

    The software supposed to prevent the engine from stopping suddenly and to transmit data to customer service is not working properly. This can lead the ‘Ready’ mode to be unavailable after the vehicle has been started, to an acceleration power's loss and to the engine suddenly cutting out while driving. This increases the risk of accidents and injuries.

    SR/01450/25 ↗
  • EU Safety Gate2008–2022

    A software error in the engine control unit prevents the malfunction indicator light (MIL) from switching on if the urea injector stops working. This can lead to higher emissions and poses a risk to the environment.

    A12/01870/23 ↗
  • EU Safety Gate2008–2018

    The teeth of the timing belt may wear off prematurely due to excessive dynamic tension in dusty conditions. As a result, the engine may stall at high engine speeds and not being able to restart, increasing the risk of…

    Volltext

    The teeth of the timing belt may wear off prematurely due to excessive dynamic tension in dusty conditions. As a result, the engine may stall at high engine speeds and not being able to restart, increasing the risk of an accident. The product does not meet the requirements laid down in the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.

    A12/01184/21 ↗
  • EU Safety Gate2008–2016

    null A problem with a component of the gearbox actuator could prevent gear changing or cause the driver to change to the wrong gear. This could lead to the vehicle moving in the opposite direction to that intended by…

    Volltext

    null A problem with a component of the gearbox actuator could prevent gear changing or cause the driver to change to the wrong gear. This could lead to the vehicle moving in the opposite direction to that intended by the driver.

    A12/0479/17 ↗
  • EU Safety Gate2013–2016

    null Possible incorrect positioning of a fuel pipe seal in the filler cap area could lead to loss of fuel when the tank is filled completely or in the event that the vehicle overturns.

    A12/0207/17 ↗
  • EU Safety Gate2012–2014

    null In the case of negative exterior temperatures, and after repeated activation of the fuel heater, an electric connection on the cover of the fuel heater can overheat. This can cause the cover to melt, allowing air…

    Volltext

    null In the case of negative exterior temperatures, and after repeated activation of the fuel heater, an electric connection on the cover of the fuel heater can overheat. This can cause the cover to melt, allowing air to enter the fuel system which could lead to stalling of the engine and loss of control of the car.

    A12/1317/15 ↗
1 weitere Rückrufe anzeigen
  • EU Safety GateErnst2010–2014

    null Fuel leakage at the junction between the fuel return pipe and the injectors on the engine, caused by progressive wear of the return pipe, can lead to the risk of fire.

    A12/2132/14 ↗