AutoDefects
Polski

Citroën C4 2013: niezawodność

o 53% więcej usterek mechanicznych niż w klasie

12 101 badań MOT egzemplarzy Citroën C4 zarejestrowanych po raz pierwszy w 2013: 31,1% nie przeszło z powodu usterki mechanicznej; mediana klasy w tym samym wieku i z tym samym przebiegiem to 20,4%.

Usterki mechaniczne
31,1%
Mediana klasy, ten sam wiek i przebieg
20,4%
Negatywne badanie (dowolny powód)
44,8%
badań MOT
12 101
Akcje przywoławcze
13

Co się psuje w zależności od przebiegu

PrzebiegBadaniaUsterki mechaniczneMediana klasy
0-50k km21915,1%9,4%
50-100k km215823,3%12,2%
100-150k km491531,6%20,6%
150k+ km480934,9%24,4%

Co się psuje w tym roczniku

UkładUsterki mechaniczne
Zawieszenie i koła16,8%
Hamulce10,1%
Silnik, wydech i emisja1,8%
Układ kierowniczy5,4%
Nadwozie, podwozie i korozja9,5%
Pasy i poduszki powietrzne1,5%
Oświetlenie i elektryka (eksploatacja)20,3%
Opony (eksploatacja)8,9%
Wycieraczki i szyba (eksploatacja)5,9%
Inne i tablice (eksploatacja)0,2%

Oficjalne akcje przywoławcze

Akcje opublikowane przez NHTSA (USA) i EU Safety Gate, w których wymieniono ten model. Czy dotyczą konkretnego auta, sprawdź po VIN.

  • EU Safety GatePoważne2009–2017

    The airbag may deteriorate over time and if deployed, excessive internal pressure may cause the inflator body to burst and metal fragments could pass through the cushion material causing injury to occupants.

    SR/02977/25 ↗
  • EU Safety GatePoważne2009–2017

    The propellant airbag inflator may experience a material alteration over time due to degradation occurring after prolonged exposure to high absolute humidity, high temperatures and high-temperature cycling. In the event…

    Pełny tekst

    The propellant airbag inflator may experience a material alteration over time due to degradation occurring after prolonged exposure to high absolute humidity, high temperatures and high-temperature cycling. In the event of an airbag being deployed, the excessive internal pressure may cause the inflator body to rupture and metal fragments may pass through the cushion material causing injury to the occupants.

    A12/01043/21 ↗
  • EU Safety GatePoważne2009–2017

    The propellant airbag inflator may experience a material alteration over time due to degradation occurring after prolonged exposure to high absolute humidity, high temperatures and high-temperature cycling. In the event…

    Pełny tekst

    The propellant airbag inflator may experience a material alteration over time due to degradation occurring after prolonged exposure to high absolute humidity, high temperatures and high-temperature cycling. In the event of an airbag being deployed, the excessive internal pressure may cause the inflator body to rupture and metal fragments may pass through the cushion material causing injury to the occupants. The product does not meet the requirements laid down in the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.

    A12/01369/21 ↗
  • EU Safety Gate2011–2015

    The programming of the ‘Stop & Start’ system is inadequate. This may cause the engine to cut out if the battery charge level is lower than the minimum load threshold required by the ‘Stop & Start’ function. This could…

    Pełny tekst

    The programming of the ‘Stop & Start’ system is inadequate. This may cause the engine to cut out if the battery charge level is lower than the minimum load threshold required by the ‘Stop & Start’ function. This could increase the risk of an accident.

    A12/0645/19 ↗
  • EU Safety Gate2012–2016

    The axle of the parking brake caliper has not been correctly sealed and might corrode. As a consequence, the parking brake may become less effective or fail completely.

    A12/1485/18 ↗
  • EU Safety Gate2011–2016

    The strut for the hatchback door may be defective. As a result, the door could suddenly drop from a raised position.

    A12/0847/18 ↗
Pokaż jeszcze 7 akcji
  • EU Safety Gate2012–2015

    Overheating of the engine may occur due to a problem with the engine control software. Overheating of the engine may lead to engine failure.

    A12/0492/18 ↗
  • EU Safety Gate2011–2014

    null Water can enter the vent mechanism for the front windscreen-wiper motor. This could result in the windscreen-wiper motor becoming completely blocked because of internal corrosion. Failure of the windscreen-wipers…

    Pełny tekst

    null Water can enter the vent mechanism for the front windscreen-wiper motor. This could result in the windscreen-wiper motor becoming completely blocked because of internal corrosion. Failure of the windscreen-wipers whilst driving in rain would lead to reduced visibility for the driver.

    A12/1522/17 ↗
  • EU Safety Gate2011–2016

    null Due to corrosion, the dampers of the rear door could break. This could result in the rear door failing to stay in the open position, leading to injuries to the user.

    A12/1523/17 ↗
  • EU Safety Gate2013–2017

    null The power terminal on the starter is incorrectly positioned which could result in the electric starter cable being in contact with the exhaust gas recirculation valve. This could lead to wear of the insulation of…

    Pełny tekst

    null The power terminal on the starter is incorrectly positioned which could result in the electric starter cable being in contact with the exhaust gas recirculation valve. This could lead to wear of the insulation of the electric starter cable and the risk of a short-circuit occurring.

    A12/0997/17 ↗
  • EU Safety Gate2009–2016

    null The cable of the catch inside the bonnet may be insufficiently secured. As a result, the bonnet might open unexpectedly while the vehicle is in motion, which could cause an accident.

    A12/0396/17 ↗
  • EU Safety Gate2012–2014

    null In the case of negative exterior temperatures, and after repeated activation of the fuel heater, an electric connection on the cover of the fuel heater can overheat. This can cause the cover to melt, allowing air…

    Pełny tekst

    null In the case of negative exterior temperatures, and after repeated activation of the fuel heater, an electric connection on the cover of the fuel heater can overheat. This can cause the cover to melt, allowing air to enter the fuel system which could lead to stalling of the engine and loss of control of the car.

    A12/1484/15 ↗
  • EU Safety Gate2012, 2013

    null The reverse locking ring of the gear lever might break. As a result first gear may be engaged instead of reverse, which could lead to the car going the wrong way and causing an accident.

    A12/0325/15 ↗