AutoDefects
Deutsch

Mercedes-Benz S-Class 2018: Zuverlässigkeit

28% weniger technische Mängel als die Klasse

2.346 MOT-Prüfungen von Mercedes-Benz S-Class mit Erstzulassung 2018: 4,4% fielen wegen eines technischen Mangels durch; der Klassenmedian bei gleichem Alter und gleicher Laufleistung liegt bei 6,2%.

Technische Mängelquote
4,4%
Klassenmedian, gleiches Alter und gleiche Laufleistung
6,2%
Durchgefallen (jeder Grund)
9,7%
MOT-Prüfungen
2.346
Rückrufe
10

Was nach Laufleistung ausfällt

LaufleistungPrüfungenTechnische MängelKlassenmedian
0-50k km3841,8%3,1%
50-100k km7945,8%5,7%
100-150k km5263,6%6,4%
150k+ km6425,0%8,4%

Was bei diesem Baujahr ausfällt

BaugruppeTechnische Mängel
Fahrwerk und Räder2,4%
Bremsen0,9%
Motor, Abgasanlage und Emissionen1,2%
Lenkung0,0%
Karosserie, Rahmen und Rost0,1%
Gurte und Airbags0,3%
Licht und Elektrik (Verschleiß)0,9%
Reifen (Verschleiß)4,7%
Wischer und Scheibe (Verschleiß)0,8%
Sonstiges und Kennzeichen (Verschleiß)0,6%

Amtliche Rückrufe

Rückrufe der US-Behörde NHTSA und des EU Safety Gate, die dieses Modell nennen. Ob ein bestimmtes Auto betroffen ist, per FIN prüfen.

  • EU Safety Gate2012–2020

    The polycarbonate roof panel located between the windscreen and the panoramic roof may not have been bonded correctly to the vehicle during a prior repair. In such cases, the adhesive bonding could gradually deteriorate…

    Volltext

    The polycarbonate roof panel located between the windscreen and the panoramic roof may not have been bonded correctly to the vehicle during a prior repair. In such cases, the adhesive bonding could gradually deteriorate and the panel could become detached from the vehicle, posing a risk to other road users.

    A12/00730/21 ↗
  • EU Safety GateErnst2016–2020

    A trapped particle may damage the sealing between the fuel rail and fuel injector, which could cause fuel to leak into the engine compartment. Consequently, leaking fuel may come into contact with hot parts of the…

    Volltext

    A trapped particle may damage the sealing between the fuel rail and fuel injector, which could cause fuel to leak into the engine compartment. Consequently, leaking fuel may come into contact with hot parts of the engine, increasing the risk of fire.

    A12/00017/22 ↗
  • EU Safety GateErnst2017–2021

    The vacuum-controlled coolant pump may not be tightly sealed between the coolant and vacuum circuits. This may result in the coolant leaking into the vacuum circuit leading to an electrochemical reaction, increasing the…

    Volltext

    The vacuum-controlled coolant pump may not be tightly sealed between the coolant and vacuum circuits. This may result in the coolant leaking into the vacuum circuit leading to an electrochemical reaction, increasing the risk of fire.

    A12/00045/22 ↗
  • EU Safety GateErnst2018–2020

    Due to the lack of documentation, there is no confirmation that the screw connections of the turbocharger’s oil-supply and oil-return pipes were correctly executed during the assembly process. In the event of a loose…

    Volltext

    Due to the lack of documentation, there is no confirmation that the screw connections of the turbocharger’s oil-supply and oil-return pipes were correctly executed during the assembly process. In the event of a loose screw connection, oil might leak at the oil-supply and/or oil-return pipe of the turbocharger.The leaking oil might then come into contact with hot components, increasing the risk of fire.

    A12/01336/20 ↗
  • EU Safety GateErnst2018, 2019

    The elastomer material of the oil feed line for the exhaust-gas turbocharger may not comply with the specification, allowing oil to leak out.Consequently, the leaking oil could come into contact with hot components,…

    Volltext

    The elastomer material of the oil feed line for the exhaust-gas turbocharger may not comply with the specification, allowing oil to leak out.Consequently, the leaking oil could come into contact with hot components, increasing the risk of fire.

    A12/01046/20 ↗
  • EU Safety Gate2017–2019

    The material used in two closure plugs on the engine might not be able to withstand the maximum load under dynamic driving conditions, allowing up to 9 liters of engine oil to escape around the plugs. Consequently, the…

    Volltext

    The material used in two closure plugs on the engine might not be able to withstand the maximum load under dynamic driving conditions, allowing up to 9 liters of engine oil to escape around the plugs. Consequently, the escaped oil could leak onto the road, posing a risk to the following traffic.

    A12/00923/20 ↗
4 weitere Rückrufe anzeigen
  • EU Safety Gate2017, 2018

    The fixing screw connecting the base holder of the manual control device may not be correctly fitted. This can impair the control over the vehicle, increasing the risk of an accident.

    A12/1794/19 ↗
  • EU Safety GateErnst2018

    The A, B and C pillar trims may not have been correctly fastened. In the event of an accident, the trims may impair the efficacy of the window airbags. If the window airbags are deployed, the trims might be detached and…

    Volltext

    The A, B and C pillar trims may not have been correctly fastened. In the event of an accident, the trims may impair the efficacy of the window airbags. If the window airbags are deployed, the trims might be detached and propelled into the passenger compartment, increasing the risk of injuries.

    A12/1514/19 ↗
  • EU Safety GateErnst2018

    The sensors in some seatbelt locks may not have been adequately manufactured. Consequently, they might not detect a correctly fastened seatbelt and thus not activate the pre-tensioner systems (electric and pyrotechnic).…

    Volltext

    The sensors in some seatbelt locks may not have been adequately manufactured. Consequently, they might not detect a correctly fastened seatbelt and thus not activate the pre-tensioner systems (electric and pyrotechnic). In the event of an accident, these might not work leading to a limited restraint capacity and increasing the risk of injury to the occupants.

    A12/0268/19 ↗
  • EU Safety GateErnst2017, 2018

    On certain vehicles, the nuts to attach the conductor rails inside the fuse box in the boot may not have been installed. This could lead to increased contact resistance between the conductor rails and, as a consequence,…

    Volltext

    On certain vehicles, the nuts to attach the conductor rails inside the fuse box in the boot may not have been installed. This could lead to increased contact resistance between the conductor rails and, as a consequence, cause a fire or failure in the engine functioning, seat belt functions and the dashboard, leading to an increased risk of accident and injury.

    A12/1153/18 ↗