AutoDefects
Polski

Audi Q3 2020: niezawodność

o 3% mniej usterek mechanicznych niż w klasie

12 756 badań MOT egzemplarzy Audi Q3 zarejestrowanych po raz pierwszy w 2020: 2,6% nie przeszło z powodu usterki mechanicznej; mediana klasy w tym samym wieku i z tym samym przebiegiem to 2,6%.

Usterki mechaniczne
2,6%
Mediana klasy, ten sam wiek i przebieg
2,6%
Negatywne badanie (dowolny powód)
7,7%
badań MOT
12 756
Akcje przywoławcze
11

Co się psuje w zależności od przebiegu

PrzebiegBadaniaUsterki mechaniczneMediana klasy
0-50k km70091,7%1,9%
50-100k km54153,5%3,5%
100-150k km3036,3%5,4%
150k+ km290,0%5,5%

Co się psuje w tym roczniku

UkładUsterki mechaniczne
Zawieszenie i koła0,2%
Hamulce2,0%
Silnik, wydech i emisja0,1%
Układ kierowniczy0,0%
Nadwozie, podwozie i korozja0,1%
Pasy i poduszki powietrzne0,2%
Oświetlenie i elektryka (eksploatacja)0,7%
Opony (eksploatacja)4,0%
Wycieraczki i szyba (eksploatacja)1,2%
Inne i tablice (eksploatacja)0,2%

Oficjalne akcje przywoławcze

Akcje opublikowane przez NHTSA (USA) i EU Safety Gate, w których wymieniono ten model. Czy dotyczą konkretnego auta, sprawdź po VIN.

  • EU Safety GatePoważne2017–2024

    Moisture ingress in the steering rack area may cause corrosion of a steering rack bolt. As a result, the bolt could fracture and lead to a loss of steering capability, increasing the risk of an accident.

    SR/03079/26 ↗
  • NHTSA (US)Poważne2019–2021

    Volkswagen Group of America, Inc. (Volkswagen) is recalling certain 2018 Tiguan, 2018-2019 Atlas, and 2019-2021 Audi Q3 vehicles. One of the bolts that attaches the steering rack to the subframe may corrode and break.…

    Pełny tekst

    Volkswagen Group of America, Inc. (Volkswagen) is recalling certain 2018 Tiguan, 2018-2019 Atlas, and 2019-2021 Audi Q3 vehicles. One of the bolts that attaches the steering rack to the subframe may corrode and break. If this happens, the steering rack housing can break.

    26V590000 ↗
  • EU Safety GatePoważne2020–2022

    The fuse in the high-voltage (HV) system may have been produced with an insufficient amount of extinguishing sand. In the event of a short circuit in the high-voltage system, a voltage flashover could occur inside the…

    Pełny tekst

    The fuse in the high-voltage (HV) system may have been produced with an insufficient amount of extinguishing sand. In the event of a short circuit in the high-voltage system, a voltage flashover could occur inside the vehicle and subsequently pose a risk of fire and injuries.

    A12/00667/22 ↗
  • EU Safety GatePoważne2020–2022

    Design engine covers installed on all affected vehicles could detach from their fixings depending on the conditions of use (e.g. very sporty driving, or poor road surfaces) and their age. A loose engine cover could come…

    Pełny tekst

    Design engine covers installed on all affected vehicles could detach from their fixings depending on the conditions of use (e.g. very sporty driving, or poor road surfaces) and their age. A loose engine cover could come into contact with the hot area of the exhaust gas turbocharger, increasing the risk of burns or fire.

    A12/00541/22 ↗
  • EU Safety Gate2020, 2021

    The bolt of the pressure-input shaft situated between the electromechanical brake servo and the brake pedal may come loose.As a result, the mechanical connection between the brake pedal and thebrake servo would no…

    Pełny tekst

    The bolt of the pressure-input shaft situated between the electromechanical brake servo and the brake pedal may come loose.As a result, the mechanical connection between the brake pedal and thebrake servo would no longer be guaranteed, increasing the risk of anaccident.In the event of an emergency, the vehicle can be immobilised by activating the electronic parking brake. The product does not meet the requirements set out in the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles

    A12/01389/21 ↗
  • EU Safety Gate2020

    Due to a manufacturing error, a weld joint between the brake pedal and the brake-pedal plate could break when the brake pedal is suddenly applied.This can result in complete detachment of the brake-pedal plate,…

    Pełny tekst

    Due to a manufacturing error, a weld joint between the brake pedal and the brake-pedal plate could break when the brake pedal is suddenly applied.This can result in complete detachment of the brake-pedal plate, increasing the risk of an accident.

    A12/00345/21 ↗
Pokaż jeszcze 5 akcji
  • EU Safety Gate2019, 2020

    Due to a manufacturing error, the belt-pulley securing ring of the steering system may not be fully engaged. As a result, the securing ring may become detached and subsequently jam with surrounding components, leading…

    Pełny tekst

    Due to a manufacturing error, the belt-pulley securing ring of the steering system may not be fully engaged. As a result, the securing ring may become detached and subsequently jam with surrounding components, leading to possible locking of the steering system.

    A12/00221/21 ↗
  • NHTSA (US)2020

    Volkswagen Group of America, Inc. (Volkswagen) is recalling certain 2020 Audi Q3 vehicles. The brake pedal plate can bend or detach under the pressure applied during sudden stopping.

    20V786000 ↗
  • EU Safety Gate2020

    The screw connection attaching the seat frame to the seat rail may not be correctly executed. As a result, it may fail in the event of an accident, increasing the risk of injury.

    A12/01482/20 ↗
  • NHTSA (US)2020

    Volkswagen Group of America, Inc. (Audi) is recalling one 2020 Audi Q3 vehicle. The driver's seat frame may have incorrectly been bolted to the seat rail.

    20V644000 ↗
  • EU Safety GatePoważne2019, 2020

    The breaking point for the release of the front passenger airbag in the console may not have been fabricated correctly. As a result, the airbag may not penetrate the console as required in the event of deployment.This…

    Pełny tekst

    The breaking point for the release of the front passenger airbag in the console may not have been fabricated correctly. As a result, the airbag may not penetrate the console as required in the event of deployment.This will impair its restraining and protective functions, increasing the risk of an injury.

    A12/00879/20 ↗