AutoDefects
English

Nissan Note 2008: reliability

13% fewer mechanical failures than the class

15,000 MOT tests of Nissan Note cars first registered in 2008: 30.2% failed for a mechanical defect; the class median at the same age and mileage is 34.8%.

Mechanical failure rate
30.2%
Class median, same age and mileage
34.8%
Failed MOT (any reason)
47.7%
MOT tests
15,000
Recalls
4

What fails, by mileage

MileageTestsMechanical failClass median
0-50k km17213.4%13.7%
50-100k km2,12516.4%24.0%
100-150k km4,94827.9%32.2%
150k+ km7,75535.7%39.8%

What fails on this year

SystemMechanical fail
Suspension and wheels21.8%
Brakes7.9%
Engine, exhaust and emissions4.3%
Steering0.6%
Body, chassis and corrosion4.7%
Seat belts and airbags3.4%
Lights and electrics (wear)30.3%
Tyres (wear)6.5%
Wipers and windscreen (wear)7.9%
Other and plates (wear)0.5%

Official recalls

Recalls published by the US NHTSA and the EU Safety Gate that name this model. Check by VIN whether a specific car is affected.

  • EU Safety GateSerious2005–2014

    The gas generator on the passenger side airbags may be defective. Metal fragments can be released when the airbag is activated, causing injuries to the occupants.

    A12/1075/19 ↗
  • EU Safety GateSerious2005–2014

    null In the event of deployment of the passenger airbag, the inflator could rupture causing metal fragments to be produced which could cause injury to the occupants of the vehicle.

    A12/1033/17 ↗
  • EU Safety GateSerious2005–2011

    null In the event of deployment of the driver’s airbag, the internal pressure of the inflator may increase abnormally and, in extreme cases, cause the driver’s airbag inflator casing to rupture.

    A12/1759/15 ↗
  • EU Safety GateSerious2001–2008

    null There is a possibility that the lower pinion needle bearing may have been omitted from the steering system during manufacture. If this is the case, the upper bearing would be overloaded and, if left in this…

    Full text

    null There is a possibility that the lower pinion needle bearing may have been omitted from the steering system during manufacture. If this is the case, the upper bearing would be overloaded and, if left in this condition, the pinion may disengage causing loss of steering control.

    A12/0872/15 ↗