Peugeot Expert / Traveller 2014: надійність
3 384 техоглядів Peugeot Expert / Traveller першої реєстрації 2014 року: 25,9% не пройшли через механічний дефект; медіана класу того ж віку й пробігу — 27,5%.
- Відмови через механіку
- 25,9%
- Медіана класу, той самий вік і пробіг
- 27,5%
- Не пройшли MOT (будь-яка причина)
- 36,8%
- техоглядів MOT
- 3 384
- Відкликання
- 8
Що ламається залежно від пробігу
| Пробіг | Техогляди | Механічні відмови | Медіана класу |
|---|---|---|---|
| 0-50k km | 67 | 6,0% | 11,6% |
| 50-100k km | 574 | 13,8% | 18,9% |
| 100-150k km | 873 | 21,1% | 26,6% |
| 150k+ km | 1 870 | 32,6% | 31,1% |
Що ламається в цьому році випуску
Офіційні відкликання
Відкликання, опубліковані NHTSA (США) та EU Safety Gate, у яких названо цю модель. Чи стосується це конкретного авто, перевіряйте за VIN.
The software supposed to prevent the engine from stopping suddenly and to transmit data to customer service is not working properly. This can lead the ‘Ready’ mode to be unavailable after the vehicle has been started,…
SR/01450/25 ↗Повний текст
The software supposed to prevent the engine from stopping suddenly and to transmit data to customer service is not working properly. This can lead the ‘Ready’ mode to be unavailable after the vehicle has been started, to an acceleration power's loss and to the engine suddenly cutting out while driving. This increases the risk of accidents and injuries.
A software error in the engine control unit prevents the malfunction indicator light (MIL) from switching on if the urea injector stops working. This can lead to higher emissions and poses a risk to the environment.
A12/01870/23 ↗The teeth of the timing belt may wear off prematurely due to excessive dynamic tension in dusty conditions. As a result, the engine may stall at high engine speeds and not being able to restart, increasing the risk of…
A12/01184/21 ↗Повний текст
The teeth of the timing belt may wear off prematurely due to excessive dynamic tension in dusty conditions. As a result, the engine may stall at high engine speeds and not being able to restart, increasing the risk of an accident. The product does not meet the requirements laid down in the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.
The support for the counterweight located beneath the rear floor may crack over time and break. As a result, the counterweight may become detached from the vehicle and fall off, posing a risk to the following traffic.
A12/1437/19 ↗null A problem with a component of the gearbox actuator could prevent gear changing or cause the driver to change to the wrong gear. This could lead to the vehicle moving in the opposite direction to that intended by…
A12/0479/17 ↗Повний текст
null A problem with a component of the gearbox actuator could prevent gear changing or cause the driver to change to the wrong gear. This could lead to the vehicle moving in the opposite direction to that intended by the driver.
null Possible incorrect positioning of a fuel pipe seal in the filler cap area could lead to loss of fuel when the tank is filled completely or in the event that the vehicle overturns.
A12/0207/17 ↗
Показати ще 2 відкликань
null In the case of negative exterior temperatures, and after repeated activation of the fuel heater, an electric connection on the cover of the fuel heater can overheat. This can cause the cover to melt, allowing air…
A12/1317/15 ↗Повний текст
null In the case of negative exterior temperatures, and after repeated activation of the fuel heater, an electric connection on the cover of the fuel heater can overheat. This can cause the cover to melt, allowing air to enter the fuel system which could lead to stalling of the engine and loss of control of the car.
null Fuel leakage at the junction between the fuel return pipe and the injectors on the engine, caused by progressive wear of the return pipe, can lead to the risk of fire.
A12/2132/14 ↗