Mercedes-Benz A-Class 2018: niezawodność
41 304 badań MOT egzemplarzy Mercedes-Benz A-Class zarejestrowanych po raz pierwszy w 2018: 7,2% nie przeszło z powodu usterki mechanicznej; mediana klasy w tym samym wieku i z tym samym przebiegiem to 5,3%.
- Usterki mechaniczne
- 7,2%
- Mediana klasy, ten sam wiek i przebieg
- 5,3%
- Negatywne badanie (dowolny powód)
- 16,3%
- badań MOT
- 41 304
- Akcje przywoławcze
- 18
Co się psuje w zależności od przebiegu
| Przebieg | Badania | Usterki mechaniczne | Mediana klasy |
|---|---|---|---|
| 0-50k km | 7548 | 4,1% | 2,7% |
| 50-100k km | 25 349 | 7,3% | 5,1% |
| 100-150k km | 7397 | 9,7% | 7,7% |
| 150k+ km | 1010 | 11,9% | 9,8% |
Co się psuje w tym roczniku
Oficjalne akcje przywoławcze
Akcje opublikowane przez NHTSA (USA) i EU Safety Gate, w których wymieniono ten model. Czy dotyczą konkretnego auta, sprawdź po VIN.
The polycarbonate roof panel located between the windscreen and the panoramic roof may not have been bonded correctly to the vehicle during a prior repair. In such cases, the adhesive bonding could gradually deteriorate…
A12/00730/21 ↗Pełny tekst
The polycarbonate roof panel located between the windscreen and the panoramic roof may not have been bonded correctly to the vehicle during a prior repair. In such cases, the adhesive bonding could gradually deteriorate and the panel could become detached from the vehicle, posing a risk to other road users.
The steering software may not correctly activate the fallback level in the event of a hardware failure. This could affect the power steering assistance and lead to the loss of steering capacity, increasing the risk of…
A12/00940/24 ↗Pełny tekst
The steering software may not correctly activate the fallback level in the event of a hardware failure. This could affect the power steering assistance and lead to the loss of steering capacity, increasing the risk of an accident.
A trapped particle may damage the sealing between the fuel rail and fuel injector, which could cause fuel to leak into the engine compartment. Consequently, leaking fuel may come into contact with hot parts of the…
A12/00017/22 ↗Pełny tekst
A trapped particle may damage the sealing between the fuel rail and fuel injector, which could cause fuel to leak into the engine compartment. Consequently, leaking fuel may come into contact with hot parts of the engine, increasing the risk of fire.
The quantity of oil in the dual-clutch gearbox may be too low or too high.This can result in impaired torque transmission, gearbox failure and potentially increased CO2 emissions.In addition, in extreme driving…
A12/01763/20 ↗Pełny tekst
The quantity of oil in the dual-clutch gearbox may be too low or too high.This can result in impaired torque transmission, gearbox failure and potentially increased CO2 emissions.In addition, in extreme driving situations, gearbox oil might leak onto the road, posing a risk to the following traffic.Moreover, the leaking gearbox oil might come into contact with hot components, increasing the risk of fire.
The quantity of oil in the dual-clutch gearbox may be too high.This can result in impaired torque transmission and potentially increased CO2 emissions.In addition, in extreme driving situations, gearbox oil might leak…
A12/01768/20 ↗Pełny tekst
The quantity of oil in the dual-clutch gearbox may be too high.This can result in impaired torque transmission and potentially increased CO2 emissions.In addition, in extreme driving situations, gearbox oil might leak onto the road, posing a risk to the following traffic.Moreover, the leaking gearbox oil might come into contact with hot components, increasing the risk of fire.
The condensed water drainage hose of the air-conditioning system may not be properly fitted. In such a case condensed water from the air conditioning system could enter the passenger compartment of the vehicle, ending…
A12/01206/20 ↗Pełny tekst
The condensed water drainage hose of the air-conditioning system may not be properly fitted. In such a case condensed water from the air conditioning system could enter the passenger compartment of the vehicle, ending up in the footwells of the driver and passenger side and in the central tunnel. As a result, any electrical components installed there could be corroded and/or subjected to short circuits or leakage currents. As a consequence, the SRS control unit could stop working, the vehicle may fail to start, the engine emergency run could be activated while driving, and the functioning of other components (e.g. the fuel pump, automatic/manual emergency call) could be adversely affected.
Pokaż jeszcze 9 akcji
The glass pane on the lifting/sliding panorama roof may not have been properly affixed. As a result, it may become completely detached, posing a risk to the following traffic.
A12/00237/20 ↗A weld on the seat-height adjustment system of the left-hand front seat may be defective and can break, causing the seat cushion to tilt forward in the event of a crash. As a result, the protective effect of the…
A12/00040/20 ↗Pełny tekst
A weld on the seat-height adjustment system of the left-hand front seat may be defective and can break, causing the seat cushion to tilt forward in the event of a crash. As a result, the protective effect of the restraint system will be impaired, increasing the risk of an injury.
The belt anchor fittings for the front seats may not have been attached in accordance with the specifications. As a result, the anchor fittings could be detached in the event of an accident, increasing the risk of an…
A12/1892/19 ↗Pełny tekst
The belt anchor fittings for the front seats may not have been attached in accordance with the specifications. As a result, the anchor fittings could be detached in the event of an accident, increasing the risk of an injury to the occupants.
The welding of the brake pedal plate to the brake pedal lever may not be sufficiently strong. Applying pressure on the left side of the brake pedal might cause the pedal plate to tilt sideways from the pedal lever. This…
A12/0948/19 ↗Pełny tekst
The welding of the brake pedal plate to the brake pedal lever may not be sufficiently strong. Applying pressure on the left side of the brake pedal might cause the pedal plate to tilt sideways from the pedal lever. This would impair the operation of the brake pedal, increasing the risk of an accident.
A bolt in the locking mechanism of the articulated trailer coupling is defective. It could break while a trailer is being towed and consequently the trailer could detach, thus increasing the risk of an accident for…
A12/0267/19 ↗Pełny tekst
A bolt in the locking mechanism of the articulated trailer coupling is defective. It could break while a trailer is being towed and consequently the trailer could detach, thus increasing the risk of an accident for following traffic.
The locking mechanisms of the right and/or left backrest might not lock correctly. This might impair the restraining effect of the backrest so that in the event of an accident there would be an increased risk of injury…
A12/0269/19 ↗Pełny tekst
The locking mechanisms of the right and/or left backrest might not lock correctly. This might impair the restraining effect of the backrest so that in the event of an accident there would be an increased risk of injury to the occupants.
No perforation has been made in the outer covering of the instrument panel to enable the deployment of the passenger airbag. In the event of an accident involving deployment of the airbag at low temperatures, sharp…
A12/0162/19 ↗Pełny tekst
No perforation has been made in the outer covering of the instrument panel to enable the deployment of the passenger airbag. In the event of an accident involving deployment of the airbag at low temperatures, sharp edges could be created on the instrument panel in the airbag's deployment area, damaging the airbag. Moreover, parts of the instrument panel may become detached, increasing the risk of injury to the occupants.
The flat conductor of the starter wiring has been incorrectly positioned, damaging the insulation of the flat conductor. The direct contact between the flat conductor and the car body may consequently lead to a short…
A12/0147/19 ↗Pełny tekst
The flat conductor of the starter wiring has been incorrectly positioned, damaging the insulation of the flat conductor. The direct contact between the flat conductor and the car body may consequently lead to a short circuit and fire.
A metal chip formed during the assembly process within the ESP hydraulic unit could block a non-return valve. As a consequence, the non-return valve might no longer be able to close, affecting performance of the…
A12/0138/19 ↗Pełny tekst
A metal chip formed during the assembly process within the ESP hydraulic unit could block a non-return valve. As a consequence, the non-return valve might no longer be able to close, affecting performance of the brake-pedal. This could increase the risk of an accident.