Hyundai Ioniq 2017: reliability
5,731 MOT tests of Hyundai Ioniq cars first registered in 2017: 7.4% failed for a mechanical defect; the class median at the same age and mileage is 8.5%.
- Mechanical failure rate
- 7.4%
- Class median, same age and mileage
- 8.5%
- Failed MOT (any reason)
- 15.7%
- MOT tests
- 5,731
- Recalls
- 9
What fails, by mileage
| Mileage | Tests | Mechanical fail | Class median |
|---|---|---|---|
| 0-50k km | 398 | 3.0% | 3.0% |
| 50-100k km | 1,792 | 6.4% | 6.1% |
| 100-150k km | 1,506 | 8.3% | 8.1% |
| 150k+ km | 2,035 | 8.6% | 12.1% |
What fails on this year
Official recalls
Recalls published by the US NHTSA and the EU Safety Gate that name this model. Check by VIN whether a specific car is affected.
The Power Relay Assembly (PRA) located underneath the rear seat may overheat.
22V459000 ↗Full text
Hyundai Motor America (Hyundai) is recalling certain 2017-2018 Ioniq HEV and Ionic PHV vehicles previously recalled under recall number 18V-704. The Power Relay Assembly (PRA) located underneath the rear seat may overheat.
The vehicle may enter a “fail-safe” mode, causing the EV Ready lamp to flash, accompanied with reduced acceleration and over all power output, which increases the risk of an accident.
A12/00069/22 ↗An unstable electrical ground may cause the vehicle to enter a fail-safe mode with reduced acceleration and power. In certain conditions while in fail-safe mode, the vehicle may accelerate after the gas pedal is…
21V944000 ↗Full text
Hyundai Motor America (Hyundai) is recalling certain 2017-2019 Ioniq electric vehicles. An unstable electrical ground may cause the vehicle to enter a fail-safe mode with reduced acceleration and power. In certain conditions while in fail-safe mode, the vehicle may accelerate after the gas pedal is released.
The main relay of the Power Relay Assembly (PRA) under the rear seat may have been insufficiently tightened. It may further loosen itself, increasing the electrical resistance, which may overheat the PRA increasing the…
A12/0111/19 ↗Full text
The main relay of the Power Relay Assembly (PRA) under the rear seat may have been insufficiently tightened. It may further loosen itself, increasing the electrical resistance, which may overheat the PRA increasing the risk of fire.
The Main Relay within the Power Relay Assembly (PRA) may have inadequate connections between its contacts, causing increased electrical resistance.
18V704000 ↗Full text
Hyundai Motor America (Hyundai) is recalling certain 2017-2018 Hyundai Ioniq Hybrid and 2018 Ioniq Plug-In Hybrid vehicles. The Main Relay within the Power Relay Assembly (PRA) may have inadequate connections between its contacts, causing increased electrical resistance.
The inner housing of the hydraulic clutch actuator (HCA) may have burrs which can damage an inner oil seal over time. As a consequence, oil might leak into the phase cap area which could cause a short circuit and the…
A12/1259/18 ↗Full text
The inner housing of the hydraulic clutch actuator (HCA) may have burrs which can damage an inner oil seal over time. As a consequence, oil might leak into the phase cap area which could cause a short circuit and the engine compartment could catch fire.
Show 3 more recalls
The Hydraulic Clutch Actuator (HCA) inner oil seal may leak, allowing oil to accumulate in the cap area, possibly resulting in an electrical short.
18V260000 ↗Full text
Hyundai Motor America (Hyundai) is recalling certain 2017 Hyundai Ioniq Hybrid vehicles. The Hydraulic Clutch Actuator (HCA) inner oil seal may leak, allowing oil to accumulate in the cap area, possibly resulting in an electrical short.
The aluminium housing of the EPCU (Electric Power Control Unit) may contain voids. Coolant could come in to contact with the control unit’s circuit board causing the vehicle to stall.
A12/0150/18 ↗Manufacturing defects within the Electronic Power Control Unit (EPCU) may allow coolant to contact the unit's circuit board.
17V532000 ↗Full text
Hyundai Motor Company (Hyundai) is recalling certain 2017 Ioniq Electric Vehicles. Manufacturing defects within the Electronic Power Control Unit (EPCU) may allow coolant to contact the unit's circuit board.